Rewinding Machine operating procedures - Start thread
1The main operator passes the inspection to confirm that the paper core and the size of the paper cut are correct.
The power-on signal informs the operator to prepare the paper. Open the paper feed roller, blower system, and paper positioning system before threading.
2. Start the rewinding machine and crawl the car at a speed of 15 meters.
3. The base paper is torn or folded into a triangle and sent to the platen roller to be delivered by the platen roller.
The paper is fed to the bottom knife roll and pressed against the horizontal roller.
4. The paper web is drawn flat and the paper trimming is aligned with the paper core and the port.
Introduce the paper edge fan to inform the main operation to stop. At this time, check the trimming situation and adjust it in time.
5. Use a piece of tape to match the paper web to the paper core, and then remove the letter immediately after sticking.
No. To inform the main operation, press the platen roller button to press the platen roller against the paper core, and start the roll paper.
Rewinding Machine operation safety regulations -
Second, the operation steps：
1. According to the production order of the day, the squad leader is responsible for arranging the material production (base paper, packaging materials, paper core);
2. Check whether the quality of the original paper texture, color, tension, elongation and other products meet the product requirements.
3. Put the original paper on the paper-removing shaft and the shaft plug must be locked. The 1575 rewinding machine is assisted by the handyman to push the original paper to the unloading frame and push it into the positioning slot. The 2900 rewinding machine uses the cylinder to lift the paper. Push the rear frame into the positioning groove of the rear frame (when the iron shaft is pushed into the positioning groove, pay attention to safety), and adjust the left and right position. When replacing the base paper, the shaft stalk and the plug must be removed with both hands and placed on the ground. It is strictly forbidden to throw or fall on the ground, and damage the floor or hurt the person;
Four release and one rewinding machine operation program ---
6. Check if the power indicator on the outside of the tension control cabinet is lit.
7. In the touch screen, you need to input or rewrite the following parameters:
1 counting length is cleared (if it is necessary to re-measure the length);
2 automatic acceleration speed (refers to the speed we reach after the automatic acceleration of the machine after pressing the acceleration button delay)
3 Automatic acceleration time (refers to the time required for the machine to automatically accelerate from zero speed to the design of the highest machine speed. The shorter the time setting, the faster the acceleration.)
8. Tension control: Set the tension of each discharge motor in the touch screen. The discharge motor mainly provides a reverse torque, generates tension on the paper surface, keeps the paper web flat, and the speed control of the discharge motor is a process of gradually increasing speed, but the line speed remains unchanged.
9. Each console has its own power switch, which can be switched on and off as needed.
10. The forward and reverse running buttons are set on the console, and the user can select the running direction according to the needs.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc