Rewinding Machine operating procedures - Start roll paper
1. The main operation starts the power-on signal and enters the roll paper state.
2. First set the information (length, diameter) of the paper roll to be rewinded.
The tightness of the paper roll adjusts the amount of tension.
3. Generally, the starting speed of the roll paper is set between 30 and 50 meters.
Step up speed, while speeding up, pay close attention to the subtle realization of the roll paper surface, such as pleats, twisting, knife edge biting, etc., should be adjusted in time to ensure the quality of the roll.
4. When the rewinder is in the normal roll, the paper will suddenly be broken due to paper disease or other reasons. The main operation will immediately press the stop button.
5.1. After the rewinder is stopped, first find the cause of the broken broach, make a broken record, and strip the external waste paper of the roll;
5.2. Instructing the main operation to start the paper feed;
5.3. After the paper web is placed on the paper, the paper is broken at the end of the paper and folded with a knife.
5.4. Pull the tape off and place it under the cut paper web. The length of the tape is two centimeters on both sides of the paper web. Cut it with a blade, then use the hand to pull it up to get the paper web to be pulled up and flattened, taped on the tape, paper. Align the interface, cut the long paper web with a knife, and finally level the adhesive tape with your hand. Immediately after the completion, remove the handle and notify the main operation to lower the platen roller and start the roll paper.
6. The main operation is strictly controlled according to the diameter and length required by the process standard. When the length standard is reached, the vehicle speed can be smoothly decelerated and the rewinding is completed.
Guolian High Speed ??Slitting Rewinder Technical Description ---
Third, the function introduction
1. The tension control of the eject roller consists of a tension sensor and an eject motor.
In the loop control loop, the paper take-off motor is an electric motor when unwinding, and is a brake generator during normal operation and parking.
2. The pressure control of the pressure roller is controlled by various sensors such as the take-up roller diameter detecting sensor.
Forming a closed-loop control system, there are three pre-made curves for different paper grades and different finished paper diameters for the operator to choose, and the actuator will be controlled according to these three different pressure curves.
3, between the two take-up bottom rollers, take the torque difference control method, corresponding to no
The same take-up diameter, the torque between the front and rear bottom rollers is distributed in different proportions.
Automatic rewinding machine speed ratio adjustment method ---
3. Adjust the curved shaft behind the punching knife. The curved shaft is finally stretched as a smooth transition axis before the web is wound up. The position of the position and the working arc size not only affect the smoothness of the paper web, but also affect the stability of the web transport. When the curved axis is too high, the paper web is scratched by the punching surface knife, and the jitter is large and the paper is easy to break. When the position is too low, the paper web is scraped to the low hole and the broken layer is easy to break. Generally, the height of the curved shaft position is adjusted so that when the paper web passes through the punching knife, the bottom layer is preferably 5~8 mm higher than the punching bottom knife, and the working arc of the curved shaft is as small as possible, and the paper can not wrinkle.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc