Rewinding Machine operating procedures - Rewinding
Firstly, the switch is automatically turned on, and then the paper is positioned to automatically unload the paper. After the unloading is completed, the main operation uses the box rule to measure the size of the rolled paper and observe the trimming of the end face and the rewinding of each end roll. Whether the end face has a burr.
Rewinding Machine common fault - The coil does not run or is broken
1. Winding tension controller is not open - Open winding tension controller switch
2, the speed of the governor is too low - increase the speed of the governor
3, did not press the reset button - press the reset button on the two tension controllers
4, the tension tension controller tension is too small - increase the winding tension controller output current
5, unwinding tension control tension is too large - reduce the unwinding tension controller output current
6, the running button is damaged - replace the run button
7, tension controller failure - contact the manufacturer
8, governor failure - contact the manufacturer
Rewinding Machine safety operation guide -
Fourth, joint operator joint quality:
Joint quality control
1 tape should not be exposed; prevent sticking between sheets.
2 The outer sheet of the joint must be flattened, straightened without wrinkles, and the end surface is not protruding.
3 When the joint is cut, the paper edge shall not be larger than 5mm and neat.
4 The outer tape of the joint must be a straight line.
5 connector label placed at the joint
6 The number of joints should be less than the specified value.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc