Adhesive Tape

Adhesive Tape

Rewinding Machine operating procedures - Rewinding
Firstly, the switch is automatically turned on, and then the paper is positioned to automatically unload the paper. After the unloading is completed, the main operation uses the box rule to measure the size of the rolled paper and observe the trimming of the end face and the rewinding of each end roll. Whether the end face has a burr.

Adhesive Tape

Rewinding Machine operation safety regulations - 

First, the preparation work before starting
1. Clean up the dust on the machine;
2. Check the circuit of the machine (whether the circuit is damaged), whether the rotating parts (bearings, gears, etc.) are loose, whether the conveying belt is intact, whether the protective device is intact, if there is an abnormality, it needs to be replaced or reported to the workshop supervisor in time;
3. Is the amount of lubricating oil (butter, oil) of the rotating parts of the machine appropriate? Is the amount of white mineral oil on the perforating knife appropriate? If not enough, add the right amount of oil;

Adhesive Tape

Four release and one rewinding machine operation program ---

First, prepare for inspection before starting the machine
1. Dust removal: Before cleaning, ensure that the work area is cleaned and there is no dust. There is no dust on the shaft. Clean it once with an air gun to remove the dust.
2, the direction of receiving and discharging: When unwinding the bar, pay attention to the direction of feeding. The discharge stick is counterclockwise. The receiving stick is clockwise.
3. The position of the gear and the position of the barrel are placed: the gear of the discharging stick and the receiving stick should be in the middle of the gear of the motor, avoiding the friction between the gear and the gear around the gear during the fine adjustment, thus causing damage to the gear or the motor; The receiving barrel should be the same on the scale of the stick.
4. Inflatable locking: After the position of the barrel is placed, use a high-pressure air gun to ventilate each barrel to ensure that each barrel is locked. (It is strictly forbidden to start the machine without inflation)
5. Induction: Manually pass the materials through the intermediate rollers and the tension sensor in sequence, and finally wrap the receiving core and fix the material head by hand. Note: Ensure that the material is neat and flat during the process of fixing the material. Put the material well and press the pressure shaft on the receiving roller.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com