Cheap Slitting Machine

Cheap Slitting Machine

Rewinding Machine operating procedures - Rewinding
Firstly, the switch is automatically turned on, and then the paper is positioned to automatically unload the paper. After the unloading is completed, the main operation uses the box rule to measure the size of the rolled paper and observe the trimming of the end face and the rewinding of each end roll. Whether the end face has a burr.

Cheap Slitting Machine

Guolian High Speed ??Slitting Rewinder Technical Description ---

Second, the system configuration
1. Main transmission part: 1 set of paper-removing brake generator, 400kW (YVP4501-6 or
1LA8357-6), one roller motor (YVP225S-4), 37kW, two pressure roller motors (YVP132S-4), 5.5kW, two coiling motors (YVP355L2-4) (one for each front and rear roller) , 315kW, 6 paper cutter motor, 0.55kW, total installed capacity 1082kw (model and power are subject to final design). The rectification feedback and the inverter unit and the tension controller matched with the above constitute a transmission control system.
2. Logic control part: PLC host 1 block.
3. The logic control system selects the S7-400 series products of SIEMENS.
4. Tension control part: 1 set of tension detection and control system, using Sweden
NOBEL products.
5. 1 set of coiling roller pressure detection and control system.
6. The diameter detecting sensor of the take-up roller.
7, with position detection, pressure detection, liquid level detection, safety detection sensor and phase
The control agency should be controlled.
8. On-site operation panel, logic control panel, and electric drive panel.

Cheap Slitting Machine

Automatic rewinding machine speed ratio adjustment method ---

3. Adjust the curved shaft behind the punching knife. The curved shaft is finally stretched as a smooth transition axis before the web is wound up. The position of the position and the working arc size not only affect the smoothness of the paper web, but also affect the stability of the web transport. When the curved axis is too high, the paper web is scratched by the punching surface knife, and the jitter is large and the paper is easy to break. When the position is too low, the paper web is scraped to the low hole and the broken layer is easy to break. Generally, the height of the curved shaft position is adjusted so that when the paper web passes through the punching knife, the bottom layer is preferably 5~8 mm higher than the punching bottom knife, and the working arc of the curved shaft is as small as possible, and the paper can not wrinkle.
 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com