Rewinding Machine structure - Ejection Department
In the rewinder system, we installed the paper roll on the paper exit frame. In order to ensure that the width of the sides of the paper web is the same, we should be moving the seasoning when
the paper roll is ejected. But the paper roll in the new structure can move with the paper exit frame,
This ensures a greater rigidity of the exit frame. In addition to manually moving the paper roll, we can also use the pneumatic, photoelectric device and electric method to adjust the axial movement
of the paper exit frame, so that the cutting edge of the winder can be narrowed, and the manual adjustment can not be achieved. Requirements.
Design and application of constant tension and load distribution control for winder---
1. Rewinder structure and working principle
The rewinder is generally composed of a unwinding roll (also referred to as a paper take-off roll), a guide roll, a slitting mechanism, a platen roll, a take-up bottom roll (including a front bottom roll and a rear bottom roll), and a double bottom roll. The machine is characterized by two rotating drums to replace and support the take-up reel, usually with or without a rotating platen roller pressed against the top of the reel in the take-up, the take-up reel is taken up The main structure (has become the front and rear bottom rollers respectively). Under normal circumstances, the surface of the front bottom roller is rough, and the surface of the rear bottom roller is relatively smooth. They are connected to the motor through the reduction gear box. The platen roller, also called the load roller, acts to create a downward pressure whose pressure is the difference between its own weight and the load roller lifting pressure. The unwinding roller is composed of a leg paper holder, a unwinding roller coupling, a unwinding roller clamping mechanism, and a unwinding motor. Longitudinal cutters generally have book holders side by side on the same axis, mainly used to cut off the change. Cut a certain width of sheet paper to the required width as needed. Two tension sensors are placed on the tension roller to receive the web tension.
Belt rewinding machine design and working principle ---
2 rear bottom roller
The platen roller device consists of a combination of devices that can be combined. The platen roller is supported by bearings on the platen beam beam.
The movable beam is fixed to the frame. The movement of the platen roller beam moves with the hydraulic cylinder attached to the beam. The platen roller is decoupled from the hydraulic cylinder during the rewinding process. The platen roller also includes a pressure sensor to measure the pressure between the platen roller and the frame.
The platen roller has a position measuring device for providing a position about the platen roller and the diameter of the paper roll. Based on the above information, the hydraulic cylinder moves in accordance with the separation design curve as the diameter of the paper roll continues to increase. The hydraulic cylinder is equipped with a hydraulic hose rupture protection valve to prevent the paper roll from suddenly falling when the hose is damaged.
The platen roller provides additional load to the paper roll at the beginning of the rewinding. At a later stage of the rewind, the pressure is released. In the final stage, the platen roller ensures that the paper roll is in place.
During the threading and changing process, the platen roller is raised to the rear of the safety lock at the top position. The safety lock prevents the platen roller from suddenly falling when the device malfunctions. The platen roller is automatically decompressed when the platen roller is lowered to the core or the base. If the lowering control is terminated before decompression, the platen roller will be activated and the platen roller will be raised to the upper position.
During the rewinding process, the contact surface between the platen roller and the paper core must be carefully observed. If the platen roller is very close to the core, special care must be taken during the rewinding process. If the core starts to vibrate, the speed must be lowered immediately. There is a vibration indicator on the pressing roller beam to facilitate speed reduction in that case.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc