Single Rewinder

Single Rewinder

Rewinding Machine Structure - Roll Paper Department:
1. Stretching device
2. support roller
3. unloader
4. transmission mechanism

Single Rewinder

Design and application of constant tension and load distribution control for winder---

3 limitations of the original control system
This paper is aimed at the transformation of the rewinder analog DC drive system. The original rewinder control system mainly has the following shortcomings and limitations:
(1) The original rewinder control system is the DC drive control system of Siemens AG of Germany. Due to the DC motor drag, the analog regulator is adjusted, the device parameters are easy to drift, resulting in the reliability and accuracy of the rewinder, and Affect the quality and efficiency of rewinding, the maximum speed is only about 600m/min, it is difficult to meet the production requirements of high-speed paper machines.
(2) The original system uses mechanical buttons and instruments to operate and monitor the production process. The information integration capability is not strong. The process parameters of many production processes cannot be obtained, which increases the labor intensity of workers' operations and the time of manual participation in production, which affects the rewinding. Machine utilization and automation.
(3) The original system is a centralized system. A large number of I/O cables are distributed between the control room and the site, which not only increases the cost but also increases the system's unreliability.
(4) Due to incomplete information of field-level equipment, online fault diagnosis, alarm, and recording functions of field-level equipment are not strong. On the other hand, it is difficult to complete the parameterization functions such as remote parameter setting and modification of field devices, which affects the maintainability of the system.

Single Rewinder

Belt rewinding machine design and working principle ---

1 belt roller device
The belt and stick set consists of two belt rollers with intermediate and end supports! A rubber support belt surrounds the belt roller. The inner surface of the support belt has a guiding profile that controls the operation of the belt. There is also a correspondingly concave surface on the belt roller. The belt roller has been joined together by a rocker and a hydraulic cylinder from below. The belt tension can be adjusted with a hydraulic cylinder during the winding process.
The motor drives the rear belt roller to run, and the other roller is carried by the belt. The belt roller is equipped with a hydraulic brake system. The belt roller bearing housing is lubricated with lubricating oil. The oil flow and temperature of the lubricating oil system are detected by the sensor. There is a directional blow tube between the two rolls to ensure that no space remains in the space between the two rolls. The lifting device has been installed under the belt. The lifting device is used for changing rolls. The lifting device comprises a hydraulic cylinder and a lifting plate interlocked with the rear bottom roller during the lifting process.
Belt roller unit:
1- bottom roller
2- rear belt roller
3- front belt roller
4- belt
5-belt telescopic hydraulic cylinder

Principle of operation
The core is placed between the back bottom roll and the back belt roll. The paper core is supported at that position throughout the initial crimping process up to a diameter of approximately 500 mm (17.9 in). The over 500 mm (17.9 in) belt begins to support the increasing area of ??the paper roll, and the weight of the roll is reached when the paper roll is particularly large. Mainly supported by a belt.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?