Adhesive Tape Rewinding Machine Large Rewinder

Adhesive Tape Rewinding Machine Large Rewinder

Rewinding Machine Structure - Control Performance Indicators
The rewinder is the last process in the papermaking process. The performance of the rewinder determines the quality of the finished paper roll. A complete rewinder must have the following properties:
1. Adjusting mechanism of pressure of the platen roller
2, support roller torque program control
3. Tension adjustment mechanism
4. Electric drive "flexible" start and proper speed program control.

Adhesive Tape Rewinding Machine Large Rewinder

Rewinding Machine operating procedures - 

First, the boot process:

4. Press the gas up axis button to inflate the gas riser shaft;
5, adjust the position of the left and right correction sensor, so that the correction position is 50%, cancel the paper-like
Effective function
6. Open the stop tension maintaining function;
Note: Before opening the tension, ensure that the product has no obvious relaxation;
7. Set the running tension and automatic running speed separately;
Note:
(1) The tension is set according to the characteristics of the product. The cigarette pack is generally about 45N, the most
Do not exceed 60N;
(2) The maximum running speed should not exceed 200m/min;

Adhesive Tape Rewinding Machine Large Rewinder

Rewinding Machine operation safety regulations - 

Second, the operation steps:

7. When the layers of paper are completely flat and enter the rewinding, the waste coils are taken out to the normal production state. 8, check the production situation:
(1) Check whether the two ends of the base paper are symmetrical. For example, the auger can adjust the auger on the unloading frame to the ends of the paper. (2) Check whether the punched paper is clear, the punching is not clear or the missing teeth are checked. Whether the knife is broken or not
Whether the wire is loose, adjust the height of the bottom knife, and mass production after inspection;
(3) Check whether the paper feeding tension of the rewinding paper is consistent, keep the paper surface flat and no wrinkles, such as inconsistency
Then adjust the paper return belt hand wheel on the paper exit frame;
(4) Check whether the paper between the embossing stick and the winding area is flat and tight, if it meets the requirements, if it does not meet the requirements,
Then adjust the gearbox handwheel (when adjusting the gearbox handwheel, you can't stop the adjustment, you need to turn it on slowly); (5) Check whether the semi-finished paper roll is tight, the diameter and weight meet the product standard requirements, and the two ends are neat (straight
The deviation of the diameter shall not exceed ±1mm, and the weight deviation shall be within ±2);
(6) Whether the width of the glue seal of the paper ball meets the standard (package standard is 10mm-15mm), the penetration of glue
No more than 3 single-layer papers;
(7) Do not arbitrarily tamper with the inverter, programmed wiring and settings in the electric box; (8) Non-operator operators must not let the machine operate without the consent of the supervisor;

Third,. After the above steps are checked normally, Slowly speed up to normal operation.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com