Single Shaft Adhesive Foam Tape Rewinding Machine

Single Shaft Adhesive Foam Tape Rewinding Machine

Rewinding Machine common fault - The platen roller does not move
1. Proportional valve is unstable. - Clean the proportional valve or replace the proportional valve to adjust the amplification signal.
2. Control failure - on-site debugging of the instrument.

Single Shaft Adhesive Foam Tape Rewinding Machine

Rewinding Machine safety operation guide - 

Seventh, production operations and quality control during the rewinding process:

4, pay attention to the quality of the rewinding of the paper roll when rewinding, found zigzag, knife, running,
If the color difference is serious, skipping, chain printing, wrinkling, violent edge, etc., the result should be stopped in time. Only after the inspector confirms can the machine be re-rolled.
5. When the rewinding operation is running, the host must be at the console, and must not leave at will to prevent accidents. Transport
The speed of lifting and lowering is slow, and the speed of the vehicle cannot exceed the prescribed limit.
6. When loading the paper core tube, it is necessary to select the paper core with the same outer diameter and the length specification in line with the quality standard.
The installation of the cylinder requires a large deviation of the outer diameter and needs to be replaced.

Single Shaft Adhesive Foam Tape Rewinding Machine

Four release and one rewinding machine operation program ---

Fourth, normal shutdown and emergency stop
1. The emergency stop is faster than the normal stop speed. After the stop, the traction roller is automatically raised. The self-locking button is urgently deactivated. In the state of emergency stop, the machine cannot be started. We need to unlock the emergency stop before the machine can be started. . When the machine does not start (observe whether the start indicator is lit), we check the status of each emergency stop button.
2. When the discharge roller is about to release the material, it must be decelerated in advance. It is guaranteed that the speed of the material is just zero when it is finished.
3. Deflating Adhere the material on the receiving roller with tape, open the pressing shaft, lift the receiving roller, place it on a stable place, deflate the receiving roller, and pull out the receiving roller.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com