Rewinding Machine common fault - The platen roller does not move
1. Proportional valve is unstable. - Clean the proportional valve or replace the proportional valve to adjust the amplification signal.
2. Control failure - on-site debugging of the instrument.
Rewinding Machine operating procedures -
First, the boot process:
1. Turn on the total power of the rewinder and the power of the detection system in turn; Note: (1) Before turning on the power, please make sure that the circuit is connected correctly and there is no short circuit;
(2) When the main power is turned on, an alarm will occur. After about 5 seconds, after resetting through the touch screen, turn on the detection power.
2. Turn on the air source switch, please ensure that the air pressure is around 6Mpa;
3. According to the paper-feeding direction in the machine state of the touch screen, the product is paper-punched; Note: (1) Please select the paper-feeding state before putting on paper;
(2) Ensure that the core is in the middle position of the inflation shaft, and the core is installed on the left and right gas rise shaft
The same location;
Four release and one rewinding machine operation program ---
Fifth, sorting out
1. After the work is finished, turn off the power and put the main power switch down.
2. Clean up the work area.
1. It is necessary to add oil to the bearings.
2. Use a manual grease gun to add butter to the bearing of the belt shaft once every six months; when the gear is missing butter, pay attention to add butter.
1. The winder has certain dangers, so it is necessary to pay attention to safety during operation.
2. Never touch the ultrasonic probe on the pressure roller.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc