Rewinding Machine common fault - The platen roller does not move
1. Proportional valve is unstable. - Clean the proportional valve or replace the proportional valve to adjust the amplification signal.
2. Control failure - on-site debugging of the instrument.
Guolian Small Winder Introduction---
First, the function: a variety of tape defective products re-rolled
Second, the characteristics:
A. The take-up shaft is driven by a DC 1HP motor and can be steplessly changed.
B. Automatic counting, convenient for setting the length of the winding.
C. The rewinding tension is adjusted by the spring, and the tension adjustment is convenient.
D. The structure of the machine is light and compact, and it is a desktop device, which is convenient to move.
Third, the specifications
1. Roller surface width: 105mm
2. Maximum discharge diameter: standard is 150mm and length is 400mm
3. Take-up diameter: Ø76mm-300mm
4. Rewind width: 12mm-100mm lengthening type is 300mm
5. Take the paper heart: paper tube 3”
6. Mechanical speed: 0~150M/min per minute
Fourth, the host configuration
1. Discharge shaft: 3" movable type (1)
2. Dispensing rack: lengthened 300mm diameter (1)
3. Main motor: DC motor 1HP (1 set)
4. Take-up tension: Spring control (1 set)
5. Length control: four-digit electronic counter (1 group)
6. Take-up shaft: 3" tube core (1 group)
Belt rewinding machine design and working principle ---
2 rear bottom roller
The roller is covered with a steel shell. It maintains a dynamic balance at a speed equivalent to the design speed. The roller has a coating and a spiral groove. Equipped with hydraulic brake system. The roll outer coating is used to attempt to increase the friction between the roll surface and the paper during rewinding. Air is discharged along the spiral groove between the roll surface and the paper roll.
The rear bottom roller has a hole. Vacuum suction is generated by a blower. This facilitates paper machine threading to ensure that the cut sheet fits snugly against the roll during roll change.
(traction) platen roller device:
1-cylinder safety valve
2- Pressing roller
3- Press roller safety lock
5- Pressing roller beam
6- Paper roll
The platen roller is used to hold the paper roll during the roll paper process. The pressure between the roller and the drum is adjusted by adjusting the pressure of the platen roller. The rewinding pressure affects the roll density and sheet tightness and winding force. In addition, the platen roller ensures that the paper roll is in an adapted position.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc