Auto Paper Slitter Rewinder Machine

Auto Paper Slitter Rewinder Machine

Rewinding Machine common fault - Longitudinal cutter swing
1. Round knife bearing wear - Replace the bearing.
2. Tool holder sliding bearing wear - Replace the bearing.
3. Lock the cylinder leak - replace or repair the cylinder.

Auto Paper Slitter Rewinder Machine

Rewinding Machine operating procedures - 

First, the boot process:

4. Press the gas up axis button to inflate the gas riser shaft;
5, adjust the position of the left and right correction sensor, so that the correction position is 50%, cancel the paper-like
Effective function
6. Open the stop tension maintaining function;
Note: Before opening the tension, ensure that the product has no obvious relaxation;
7. Set the running tension and automatic running speed separately;
Note:
(1) The tension is set according to the characteristics of the product. The cigarette pack is generally about 45N, the most
Do not exceed 60N;
(2) The maximum running speed should not exceed 200m/min;

Auto Paper Slitter Rewinder Machine

Rewinder mechanical structure and control process ---

 

Second, the main structure of the winder

2.2 Longitudinal section
In the mechanical system of the winder, the slitting mechanism is a very important part of the winder. In order to ensure a straight and smooth cutting edge, the quality control of the finished paper roll plays an important role in ensuring the volume. It is easy and can reduce the fluffing during printing. The slitting mechanism should be installed as close as possible to the paper roll so that it can produce a lateral movement more than necessary during the process of cutting the web without curling.
The high-speed rewinding paper conveying system is also very important in the application. The old-fashioned rewinding machine is mainly handled by manual. With the increase of the speed of the rewinding machine, the manual can no longer be processed. There are two ways to transport the paper side of the reel: fan direct pumping and venturi suction. The direct drawing type of the fan mainly uses a centrifugal fan, and the fan is placed under the floor. The inlet of the fan and the air duct near the longitudinal cutting edge are connected to each other, and the blade of the fan is also equipped with a wind blade. When the fan is sucked, it will be broken by the blade and then sent to the water pulper. However, since the edge of the paper has to pass through the inside of the fan, the blade transported by this type of paper is very worn and needs to be changed frequently. Venturi suction is also used in the high-pressure centrifugal fan, but the paper edge does not pass through the fan, directly the longitudinal cutting edge of the duct into the venturi pipe, the wind machine generates negative pressure in the venturi, and then the paper While washing the venturi tube and then feeding it to the water pulper, the paper edge conveyed at this time is continuous. The disadvantage of this method is that when the speed of the winder is relatively high, the power of the selected fan is large, which will increase the operation. Cost, increase loss.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com