Rewinding Machine common fault - Longitudinal cutter swing
1. Round knife bearing wear - Replace the bearing.
2. Tool holder sliding bearing wear - Replace the bearing.
3. Lock the cylinder leak - replace or repair the cylinder.
Rewinding Machine operating procedures -
First, the boot process:
8, set the minimum winding diameter of the shaft, the size is generally 5mm based on the diameter of the core;
9. Open the detection software and load the corresponding product template;
Note: If it is a new product, please model according to the product modeling method, then load the template; 10. Create a new train and start testing;
11. Select the running direction and press the run button to resume the normal operation of the winder.
Rewinder mechanical structure and control process ---
Second, the main structure of the winder
2.3 Rolling Department
1. Stretching device
The stretching device of the rewinder is set to keep the paper web slit after slitting. In some paper cutting knives, the stretcher is also used. The main function is to eliminate the texture and slack of the paper web. Mainly, it can maintain the good operation of slitting. There are three types of stretchers that we often use today: D-shaped stretches, curved rollers, and Z-type double-bar stretchers.
2, support roller
The backup roll is mainly used to support the paper roll, which is composed of a controlled cast iron roll or a general tube roll. The roller body is mainly cast iron pipe and steel pipe, and its diameter is usually 400-700 mm or more according to the width of the winder. The center-to-center ratio between the rolls of the backup roll should be greater than the roll diameter. Only at such a distance, the roll core does not get caught in the middle of the roll when the support roll begins to curl.
When the winder is running at high speed, in order to avoid vibration during high-speed operation, the design of the backup roller must be minimal when supporting the paper roll. The radius is a function expression of the speed and width of the winder, mainly by allowable The critical speed and the degree of winding are determined because at this time the diameter of the backup roll has less chance of producing a defect in the roll hardness than the small diameter support roll. When coiling coated paper or very thin paper, we should consider using a larger diameter backup roll. On a rewinder with a small width, we generally use a 600mm roll diameter.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc