Rewinding Machine common fault - Longitudinal cutter swing
1. Round knife bearing wear - Replace the bearing.
2. Tool holder sliding bearing wear - Replace the bearing.
3. Lock the cylinder leak - replace or repair the cylinder.
Automatic rewinding machine speed ratio adjustment method ---
The rewinding machine is the first station of the production line equipment of the welcoming machine. The good running condition of the rewinding machine directly affects the quality and production efficiency of the post-processing welcoming paper. The rewinding machine should be able to operate normally and in a good production state. In addition to the good and non-damage of the components, the reasonable adjustment and control of the transmission ratio of the whole machine is very important.
When the rewinding machine is produced, the original paper web is conveyed by five transmission rollers and belts, that is, a paper feeding belt, a curved roller, a rear platen roller, a front platen roller, a winding roller, and the like. Each of the base papers is thin, the elongation is limited, and the transmission speed ratio is unstable, and the paper web is easy to wrinkle and be broken during the continuous acceleration and deceleration operation of the winder. Reasonable adjustment and control of the speed of each drive roller and paper feed belt can greatly reduce the phenomenon that the paper web is broken. After many daily adjustments, the author summarizes the following key adjustment methods. 1. Stable paper feed belt conveys the line speed of the original paper web. The paper feeding belt of the rewinding machine is driven by the V-belt through the stepless speed-regulating wheel. When the output torque is large, the driving V-belt is close to the outer edge of the speed-regulating wheel, and the transmission speed will be more stable. In order to achieve such a stable transmission effect, the speed ratio of the main gearbox can be adjusted step by step to make the speed of the winding roller slower, and at the same time adjust the speed control handwheels of the paper feed belt of the original paper frame, so that the three sets of transmission triangle belts are in The outer edge of the stepless speed regulation wheel is in a reasonable position until the winding speed of the winding roller and the paper feeding belt are the same.
Belt rewinding machine design and working principle ---
2 rear bottom roller
The roller is covered with a steel shell. It maintains a dynamic balance at a speed equivalent to the design speed. The roller has a coating and a spiral groove. Equipped with hydraulic brake system. The roll outer coating is used to attempt to increase the friction between the roll surface and the paper during rewinding. Air is discharged along the spiral groove between the roll surface and the paper roll.
The rear bottom roller has a hole. Vacuum suction is generated by a blower. This facilitates paper machine threading to ensure that the cut sheet fits snugly against the roll during roll change.
(traction) platen roller device:
1-cylinder safety valve
2- Pressing roller
3- Press roller safety lock
5- Pressing roller beam
6- Paper roll
The platen roller is used to hold the paper roll during the roll paper process. The pressure between the roller and the drum is adjusted by adjusting the pressure of the platen roller. The rewinding pressure affects the roll density and sheet tightness and winding force. In addition, the platen roller ensures that the paper roll is in an adapted position.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc