Rewinding Machine common fault - The coil is not tight during operation
1. Unwinding tension controller is not open - Open unwinding tension controller switch
2, did not press the reset button - press the reset button on the two tension controllers
3, the unwinding tension controller tension is too small - increase the unwinding tension controller output current
4, tension controller failure - contact the manufacturer
Rewinding Machine operating procedures -
Two: shutdown process:
1. Click the “Stop Detection” button and use the ICW program “Shutdown”;
2. Turn off the detection system switch;
3. Turn off the total power switch of the winder;
4. Close the total air valve.
Four release and one rewinding machine operation program ---
Fifth, sorting out
1. After the work is finished, turn off the power and put the main power switch down.
2. Clean up the work area.
1. It is necessary to add oil to the bearings.
2. Use a manual grease gun to add butter to the bearing of the belt shaft once every six months; when the gear is missing butter, pay attention to add butter.
1. The winder has certain dangers, so it is necessary to pay attention to safety during operation.
2. Never touch the ultrasonic probe on the pressure roller.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc