Slitting Rewinding Machine For Bopp

Slitting Rewinding Machine For Bopp

Rewinding Machine common fault - The coil is not tight during operation
1. Unwinding tension controller is not open - Open unwinding tension controller switch
2, did not press the reset button - press the reset button on the two tension controllers
3, the unwinding tension controller tension is too small - increase the unwinding tension controller output current
4, tension controller failure - contact the manufacturer

Slitting Rewinding Machine For Bopp

Rewinding Machine operation safety regulations - 

Second, the operation steps:

7. When the layers of paper are completely flat and enter the rewinding, the waste coils are taken out to the normal production state. 8, check the production situation:
(1) Check whether the two ends of the base paper are symmetrical. For example, the auger can adjust the auger on the unloading frame to the ends of the paper. (2) Check whether the punched paper is clear, the punching is not clear or the missing teeth are checked. Whether the knife is broken or not
Whether the wire is loose, adjust the height of the bottom knife, and mass production after inspection;
(3) Check whether the paper feeding tension of the rewinding paper is consistent, keep the paper surface flat and no wrinkles, such as inconsistency
Then adjust the paper return belt hand wheel on the paper exit frame;
(4) Check whether the paper between the embossing stick and the winding area is flat and tight, if it meets the requirements, if it does not meet the requirements,
Then adjust the gearbox handwheel (when adjusting the gearbox handwheel, you can't stop the adjustment, you need to turn it on slowly); (5) Check whether the semi-finished paper roll is tight, the diameter and weight meet the product standard requirements, and the two ends are neat (straight
The deviation of the diameter shall not exceed ±1mm, and the weight deviation shall be within ±2);
(6) Whether the width of the glue seal of the paper ball meets the standard (package standard is 10mm-15mm), the penetration of glue
No more than 3 single-layer papers;
(7) Do not arbitrarily tamper with the inverter, programmed wiring and settings in the electric box; (8) Non-operator operators must not let the machine operate without the consent of the supervisor;

Third,. After the above steps are checked normally, Slowly speed up to normal operation.

Slitting Rewinding Machine For Bopp

Guolian High Speed ??Slitting Rewinder Technical Description ---

The specific technical structure is described as follows:

Part 1: Mechanical parts
The mechanical part mainly consists of a paper exiting section, a paper cutting section, a double curved roller section, a paper winding section, and an automatic paper guiding section.
1. Ejection department:
The structure is all welded by steel plate, equipped with an empty paper roll temporary storage guide rail. The paper-removing roller is locked on the paper-removing frame by the hydraulic operating lever. After the paper is finished, the paper-returning core is pushed onto the guide rail to replace the paper. Roll and start-up operation saves time. A bumper is attached to the end of the exit frame rail to reduce vibration and noise caused by the roll change.
The coupling clutch is located between the paper roller and the brake motor, hydraulically operated, and is interlocked with the hook safety anti-lift device. The crane hook cannot lift the empty paper return shaft before the roll paper completes the clutch has been disengaged. Security performance.
With brake generator drive and hydraulic control, the paper return frame is horizontally adjusted by hydraulic motor and has a lateral swing function with a maximum swing of ±50mm. The emergency brake uses a brake generator and a hydraulic disc brake. The brake is imported from abroad, with small volume, large braking torque and good reliability.

 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com