Automatic Ribbon Tape Rewinding Machine

Automatic Ribbon Tape Rewinding Machine

Rewinding Machine common fault - The coil is not tight during operation
1. Unwinding tension controller is not open - Open unwinding tension controller switch
2, did not press the reset button - press the reset button on the two tension controllers
3, the unwinding tension controller tension is too small - increase the unwinding tension controller output current
4, tension controller failure - contact the manufacturer

Automatic Ribbon Tape Rewinding Machine

Four release and one rewinding machine operation program ---

6. Check if the power indicator on the outside of the tension control cabinet is lit.
7. In the touch screen, you need to input or rewrite the following parameters:
1 counting length is cleared (if it is necessary to re-measure the length);
2 automatic acceleration speed (refers to the speed we reach after the automatic acceleration of the machine after pressing the acceleration button delay)
3 Automatic acceleration time (refers to the time required for the machine to automatically accelerate from zero speed to the design of the highest machine speed. The shorter the time setting, the faster the acceleration.)
8. Tension control: Set the tension of each discharge motor in the touch screen. The discharge motor mainly provides a reverse torque, generates tension on the paper surface, keeps the paper web flat, and the speed control of the discharge motor is a process of gradually increasing speed, but the line speed remains unchanged.
9. Each console has its own power switch, which can be switched on and off as needed.
10. The forward and reverse running buttons are set on the console, and the user can select the running direction according to the needs.

Automatic Ribbon Tape Rewinding Machine

Rewinder mechanical structure and control process ---

Third, the rewinding machine control performance indicators
The rewinder is the last process in the papermaking process. The performance of the rewinder determines the quality of the finished paper roll. A complete rewinder must have the following properties:

3. Tension adjustment mechanism
It is generally believed that web tension control is one of the important factors affecting the tightness of the paper roll. The most important function of flattening the paper web during the rewinding process is the web tension, and the web tension must be kept stable before the paper can be avoided. The lateral movement of the web allows the rolled out finished paper roll to meet the requirements. However, the web tension is only affected when the finished paper roll is rolled up. Since we are using a double bottom roller lower paper rewinding machine, the paper web must pass through the back bottom roller to be wound on the paper roll. The roller will isolate most of the tension, and only a small amount of tension can be transferred to the finished paper roll, which means that if there is tension to control the hardness of the paper roll, if the hardness of the paper roll changes little, The tension will change a lot. The key factors affecting the hardness of the paper roll are the pressure of the platen roller and the torque difference between the front and rear bottom rollers. The effect of the web tension on the hardness of the paper roll is not great because it is not a critical factor. 4. Electric drive "flexible" start and proper speed program control The starting of the winder is of course smoother and better, so that the paper web can be prevented from being subjected to the impact of tension, and the breakage can be reduced and the paper roll can be improved. Rewind quality. In order to meet such requirements, we often add a given integrator to the speed and current of the speed regulation system. This is beneficial to the start of the winder. Through analysis, we can know that if the system is to start more smoothly, give The larger the time constant of the integrator, the better, so the integral time constant of a given integrator can be adjusted over a large range to suit the processing requirements.
From the above four points, we can see that the electronic control system must have adjustment skills to meet the rewinding process.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?