Tape Measure

Tape Measure

Rewinding Machine common fault - The coil is not tight during operation
1. Unwinding tension controller is not open - Open unwinding tension controller switch
2, did not press the reset button - press the reset button on the two tension controllers
3, the unwinding tension controller tension is too small - increase the unwinding tension controller output current
4, tension controller failure - contact the manufacturer

Tape Measure

Automatic rewinding machine speed ratio adjustment method ---

3. Adjust the curved shaft behind the punching knife. The curved shaft is finally stretched as a smooth transition axis before the web is wound up. The position of the position and the working arc size not only affect the smoothness of the paper web, but also affect the stability of the web transport. When the curved axis is too high, the paper web is scratched by the punching surface knife, and the jitter is large and the paper is easy to break. When the position is too low, the paper web is scraped to the low hole and the broken layer is easy to break. Generally, the height of the curved shaft position is adjusted so that when the paper web passes through the punching knife, the bottom layer is preferably 5~8 mm higher than the punching bottom knife, and the working arc of the curved shaft is as small as possible, and the paper can not wrinkle.
 

Tape Measure

Belt rewinding machine design and working principle ---

2 rear bottom roller
The roller is covered with a steel shell. It maintains a dynamic balance at a speed equivalent to the design speed. The roller has a coating and a spiral groove. Equipped with hydraulic brake system. The roll outer coating is used to attempt to increase the friction between the roll surface and the paper during rewinding. Air is discharged along the spiral groove between the roll surface and the paper roll.
Vacuum drum
The rear bottom roller has a hole. Vacuum suction is generated by a blower. This facilitates paper machine threading to ensure that the cut sheet fits snugly against the roll during roll change.
(traction) platen roller device:
1-cylinder safety valve
2- Pressing roller
3- Press roller safety lock
4- Photocell
5- Pressing roller beam
6- Paper roll
The platen roller is used to hold the paper roll during the roll paper process. The pressure between the roller and the drum is adjusted by adjusting the pressure of the platen roller. The rewinding pressure affects the roll density and sheet tightness and winding force. In addition, the platen roller ensures that the paper roll is in an adapted position.
Construction

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com