Paper Tape

Paper Tape

Rewinding Machine common fault - The coil does not run or is broken
1. Winding tension controller is not open - Open winding tension controller switch
2, the speed of the governor is too low - increase the speed of the governor
3, did not press the reset button - press the reset button on the two tension controllers
4, the tension tension controller tension is too small - increase the winding tension controller output current
5, unwinding tension control tension is too large - reduce the unwinding tension controller output current
6, the running button is damaged - replace the run button
7, tension controller failure - contact the manufacturer
8, governor failure - contact the manufacturer

Paper Tape

Rewinding Machine operation safety regulations - 

Fourth, other requirements in the production process
1. Rolling paper or paper jam of a certain part of the machine must be stopped. Use the jog function to remove the paper. The original paper should be carefully operated when it passes through the embossing device, the crimping device, the paper feed roller and the punching knife. It is strictly prohibited when the machine is running. Wipe and refuel the rotating parts in the state to avoid injury accidents;
2. During the production process, the gears, pulleys, chains and other components of the machine must not be allowed to entangle with paper scraps, ropes, etc., and the air pipe must not leak. The trachea, electric wires, etc. can not be fixed with rope or adhesive tape, which affects the appearance;

3. The waste paper can not be thrown anywhere in the production process, must be loaded into the designated waste paper bag to keep the production site clean.
4. The original paper core produced during the production process must be placed in the designated place;

Paper Tape

Guolian High Speed ??Slitting Rewinder Technical Description ---

The specific technical structure is described as follows:

Part 1: Mechanical parts
The mechanical part mainly consists of a paper exiting section, a paper cutting section, a double curved roller section, a paper winding section, and an automatic paper guiding section.
1. Ejection department:
The structure is all welded by steel plate, equipped with an empty paper roll temporary storage guide rail. The paper-removing roller is locked on the paper-removing frame by the hydraulic operating lever. After the paper is finished, the paper-returning core is pushed onto the guide rail to replace the paper. Roll and start-up operation saves time. A bumper is attached to the end of the exit frame rail to reduce vibration and noise caused by the roll change.
The coupling clutch is located between the paper roller and the brake motor, hydraulically operated, and is interlocked with the hook safety anti-lift device. The crane hook cannot lift the empty paper return shaft before the roll paper completes the clutch has been disengaged. Security performance.
With brake generator drive and hydraulic control, the paper return frame is horizontally adjusted by hydraulic motor and has a lateral swing function with a maximum swing of ±50mm. The emergency brake uses a brake generator and a hydraulic disc brake. The brake is imported from abroad, with small volume, large braking torque and good reliability.

 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com