Rewinding Machine common fault - The coil does not run or is broken
1. Winding tension controller is not open - Open winding tension controller switch
2, the speed of the governor is too low - increase the speed of the governor
3, did not press the reset button - press the reset button on the two tension controllers
4, the tension tension controller tension is too small - increase the winding tension controller output current
5, unwinding tension control tension is too large - reduce the unwinding tension controller output current
6, the running button is damaged - replace the run button
7, tension controller failure - contact the manufacturer
8, governor failure - contact the manufacturer
Automatic rewinding machine speed ratio adjustment method ---
2. Adjust the paper-pressing gap of the platen roller so that the paper web can be smoothly conveyed between the paper feeding belt and the winding roller. The rear platen roller is the intermediate link of the paper web conveying process. If the adjusted gap is too small, the paper web is easy to wrinkle and sag. When the gap is too large, the three layers of paper are not combined together to facilitate delamination and fault, which affects the speed of the paper feed and Rewind quality. When adjusting the paper-pressing roller, the paper-pressing gap should be gradually increased from small to large, so that the paper web can be locked without sag and not drooping.
Belt rewinding machine design and working principle ---
2 rear bottom roller
The roller is covered with a steel shell. It maintains a dynamic balance at a speed equivalent to the design speed. The roller has a coating and a spiral groove. Equipped with hydraulic brake system. The roll outer coating is used to attempt to increase the friction between the roll surface and the paper during rewinding. Air is discharged along the spiral groove between the roll surface and the paper roll.
The rear bottom roller has a hole. Vacuum suction is generated by a blower. This facilitates paper machine threading to ensure that the cut sheet fits snugly against the roll during roll change.
(traction) platen roller device:
1-cylinder safety valve
2- Pressing roller
3- Press roller safety lock
5- Pressing roller beam
6- Paper roll
The platen roller is used to hold the paper roll during the roll paper process. The pressure between the roller and the drum is adjusted by adjusting the pressure of the platen roller. The rewinding pressure affects the roll density and sheet tightness and winding force. In addition, the platen roller ensures that the paper roll is in an adapted position.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc