Insulating Tape

Insulating Tape

Rewinding Machine common fault - Rolls are not collected
1. The original coil is not uniform - Finish the original coil to ensure that the original coil is neat
2, paper core size head - check the paper core
3, only start a short period of time - normal phenomenon,
4, bearing damage - bearing damage is often accompanied by abnormal noise, pay attention to check the bearing, found that the damage is replaced in time
5, shaft damage - contact the manufacturer

Insulating Tape

Rewinding Machine operating procedures - 

First, the boot process:
1. Turn on the total power of the rewinder and the power of the detection system in turn; Note: (1) Before turning on the power, please make sure that the circuit is connected correctly and there is no short circuit;
(2) When the main power is turned on, an alarm will occur. After about 5 seconds, after resetting through the touch screen, turn on the detection power.
2. Turn on the air source switch, please ensure that the air pressure is around 6Mpa;
3. According to the paper-feeding direction in the machine state of the touch screen, the product is paper-punched; Note: (1) Please select the paper-feeding state before putting on paper;
(2) Ensure that the core is in the middle position of the inflation shaft, and the core is installed on the left and right gas rise shaft
The same location;

Insulating Tape

Rewinder mechanical structure and control process ---

 

Second, the main structure of the winder
2.1 Ejection Department
In the rewinder system, we installed the paper roll on the paper exit frame. In order to ensure that the width of the sides of the paper web is the same, we should be moving the seasoning when the paper roll is ejected. However, the paper roll in the new structure can be moved together with the paper exit frame, which ensures greater rigidity of the paper exit frame. In addition to manually moving the paper roll, we can also use the pneumatic, photoelectric device and electric method to adjust the axial movement of the paper exit frame, so that the cutting edge of the winder can be narrowed, and the manual adjustment can not be achieved. Requirements.
We have a coupling on the reel of the unwinding roll. When working, we can use a pneumatic device to connect the brake to the motor. We can know that when the high-speed winder is started, the required acceleration time from zero to 2000m/min can be completed within 50~60s, and the deceleration time required for braking is 40s. Or even shorter, so we need to consider the maximum diameter and the maximum braking speed of the paper-removing brake on the winder to reduce the paper loss of the paper-cut, or it will cause a lot of waste. In the selection of the brakes of the eject roll, we often use brakes for starting brakes, magnetic brakes and mechanical brakes. In the usual case, we use the combination of the brake motor and other brake devices. When we press the paper, the paper roll started by the DC motor can enter the acceleration and working state and can be operated by the braking of the DC motor. Control, the tension control of the paper web, in the case of emergency stop, we can use the DC motor and other brakes together to stop the paper roll at the fastest speed.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com