Gold Tape

Gold Tape

Rewinding Machine common fault - Rolls are not collected
1. The original coil is not uniform - Finish the original coil to ensure that the original coil is neat
2, paper core size head - check the paper core
3, only start a short period of time - normal phenomenon,
4, bearing damage - bearing damage is often accompanied by abnormal noise, pay attention to check the bearing, found that the damage is replaced in time
5, shaft damage - contact the manufacturer

Gold Tape

Rewinding Machine operation safety regulations - 

Fourth, other requirements in the production process:

5. When an abnormality or malfunction occurs in the production process, the machine must be turned off and checked and repaired. If the abnormality or failure is not handled, the workshop supervisor should be reported in time;
6. The perforation line must be inspected every half hour during the production process. If the perforation line is unqualified, it must be shut down immediately;
7. Every paper change must be weighed twice in the production process. If the weight of the original paper is quantitative, the texture and elongation are unstable, the number of knots should be adjusted at any time, the pressure of the riding stick should be adjusted, and the gearbox should be adjusted. The paper is elastically adjusted to meet the product diameter requirements, and the weighing is tracked to see if the weight of the product meets the standard.
8, at any time to patrol the quality of the product.

Gold Tape

Rewinder mechanical structure and control process ---

Third, the rewinding machine control performance indicators
The rewinder is the last process in the papermaking process. The performance of the rewinder determines the quality of the finished paper roll. A complete rewinder must have the following properties:
1. Adjusting mechanism of pressure of the platen roller
As the rewinder continuously performs rewinding, the diameter of the finished paper roll is gradually increased, and the weight of the finished paper roll is also gradually increasing, so that the contact points of the finished paper roll with the front and rear bottom rolls are also changing. So you can come to a conclusion like this:
If the pressure of the platen roller is kept constant and does not change, the pressure between the contact points of the finished paper roll and the front and rear bottom rolls is not guaranteed to be constant, and the change in the contact point causes the pressure generated between them to change accordingly. Therefore, if we want the paper roll to reach the best form, we must adjust the pressure exerted by the platen roller to compensate for the influence of the above two factors. Only in this way can the pressure between the front and rear bottom rollers and the finished paper roll be guaranteed. Variety.
2, support roller torque program control In the rewinding process of the finished paper roll, in order to obtain high quality finished paper roll, the speed control or the support roller torque should meet certain conditions, if the speed control is used, the support roller The speed between the two should be less than 0.2%. As the diameter of the paper roll increases, the speed of the two supporting rollers must be close. Only in this way can the high quality finished paper roll be rewinded, but some quick checking systems cannot consider this design. 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com