Rewinding Machine safety operation guide -
Second, the rewinding machine is opened and shut down:
1. Check the equipment thoroughly before starting the machine to check whether the round knife and the bottom knife are in good condition.
2. Whether the size of the round knife meets the requirements of finished products and cutting specifications
3. Hang the rewinding paper roller on the paper feeding frame, and make the brake and roller contact with each other.
Whether the fuse cover on both sides of the core and the barrel of the core is covered.
Rewinding Machine operation safety regulations -
Second, the operation steps：
1. According to the production order of the day, the squad leader is responsible for arranging the material production (base paper, packaging materials, paper core);
2. Check whether the quality of the original paper texture, color, tension, elongation and other products meet the product requirements.
3. Put the original paper on the paper-removing shaft and the shaft plug must be locked. The 1575 rewinding machine is assisted by the handyman to push the original paper to the unloading frame and push it into the positioning slot. The 2900 rewinding machine uses the cylinder to lift the paper. Push the rear frame into the positioning groove of the rear frame (when the iron shaft is pushed into the positioning groove, pay attention to safety), and adjust the left and right position. When replacing the base paper, the shaft stalk and the plug must be removed with both hands and placed on the ground. It is strictly forbidden to throw or fall on the ground, and damage the floor or hurt the person;
Four release and one rewinding machine operation program ---
Second, the machine starts
1. Press the warning button and delay for about 2 seconds. At the same time, the alarm sounds, and then press the start button to start the machine.
2. When the machine starts, fine-tune the discharge roller to ensure that the material is flush at the receiving roller. During the fine adjustment process, the gear is not rubbed against the periphery.
3. When the machine is running, no objects are allowed between the ultrasonic probe and the material axis. This will cause the machine to stop working.
Third, automatic acceleration
When the accelerator button is pressed and delayed for about 3 seconds, the machine automatically accelerates to the required maximum speed (set in the touch screen), and the deceleration button is pressed once during the acceleration process to automatically accelerate and stop.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc