Rewinding Machine safety operation guide -
Third, the rewinding machine opening and closing operation sequence:
2. When the paper roll reaches the specified rewinding diameter (meters), the working speed will slowly drop.
After the paper roll reaches the specified diameter (meters), press the “stop” switch. After the quality inspector has measured the paper roll and the appearance quality, tape the outermost piece of paper with a tape and stick the paper. The inner core of the core barrel is pulled out (the thimble) and the bottom knife roll is lifted to remove the paper roll.
3, the rewinding machine should have a long downtime, stop the paper side fan, and do a good job of surrounding sanitation.
Rewinding Machine operating procedures -
First, the boot process:
1. Turn on the total power of the rewinder and the power of the detection system in turn; Note: (1) Before turning on the power, please make sure that the circuit is connected correctly and there is no short circuit;
(2) When the main power is turned on, an alarm will occur. After about 5 seconds, after resetting through the touch screen, turn on the detection power.
2. Turn on the air source switch, please ensure that the air pressure is around 6Mpa;
3. According to the paper-feeding direction in the machine state of the touch screen, the product is paper-punched; Note: (1) Please select the paper-feeding state before putting on paper;
(2) Ensure that the core is in the middle position of the inflation shaft, and the core is installed on the left and right gas rise shaft
The same location;
Rewinder mechanical structure and control process ---
Second, the main structure of the winder
2.4 Pressure mechanism
1, the platen roller
First, in the rewinder system, the platen roller has a significant impact on the tightness control of the paper roll. Among them, the pressure adjusting mechanism plays a role of keeping the pressure of the paper roll and the supporting roll nip constant, and the main purpose is to prevent the paper roll from slipping or being wound too tight at the beginning of the work. The paper roll slips because the paper roll is too light, and the winding is too tight because the pressure is too high until the rewinding to the later stage. In the modern rewinder system, the platen roller is automatically controlled, so that the paper can be additionally applied. The force.
2. Hydraulic (air pressure) suspension mechanism
Under normal circumstances, the adjustable pressure actuators use hydraulic suspension scale mechanism. We install a potentiometer attached to the platen roller to display the diameter of the finished paper roll, which is sent through the potentiometer. The signal is transmitted to the pressure program control unit to calculate the pressure, so that the oil pressure in the suspension scale can be changed, thereby achieving pressure control of the platen roller.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc