Rewinding Machine safety operation guide -
Fourth, joint operator joint quality:
1 found that the paper has a broken rewinder
2 peel off the damaged paper that affects the quality at the break of the rewinding and rewinding paper roll, and draw the paper edge Qi.
3 first cut a piece of paper, paste double-sided tape (or according to process requirements)
4 Stick the other side of the paper together, cut the paper, and attach the connector label.
Rewinding Machine operation safety regulations -
Second, the operation steps：
7. When the layers of paper are completely flat and enter the rewinding, the waste coils are taken out to the normal production state. 8, check the production situation:
(1) Check whether the two ends of the base paper are symmetrical. For example, the auger can adjust the auger on the unloading frame to the ends of the paper. (2) Check whether the punched paper is clear, the punching is not clear or the missing teeth are checked. Whether the knife is broken or not
Whether the wire is loose, adjust the height of the bottom knife, and mass production after inspection;
(3) Check whether the paper feeding tension of the rewinding paper is consistent, keep the paper surface flat and no wrinkles, such as inconsistency
Then adjust the paper return belt hand wheel on the paper exit frame;
(4) Check whether the paper between the embossing stick and the winding area is flat and tight, if it meets the requirements, if it does not meet the requirements,
Then adjust the gearbox handwheel (when adjusting the gearbox handwheel, you can't stop the adjustment, you need to turn it on slowly); (5) Check whether the semi-finished paper roll is tight, the diameter and weight meet the product standard requirements, and the two ends are neat (straight
The deviation of the diameter shall not exceed ±1mm, and the weight deviation shall be within ±2);
(6) Whether the width of the glue seal of the paper ball meets the standard (package standard is 10mm-15mm), the penetration of glue
No more than 3 single-layer papers;
(7) Do not arbitrarily tamper with the inverter, programmed wiring and settings in the electric box; (8) Non-operator operators must not let the machine operate without the consent of the supervisor;
Third,. After the above steps are checked normally, Slowly speed up to normal operation.
Four release and one rewinding machine operation program ---
Fourth, normal shutdown and emergency stop
1. The emergency stop is faster than the normal stop speed. After the stop, the traction roller is automatically raised. The self-locking button is urgently deactivated. In the state of emergency stop, the machine cannot be started. We need to unlock the emergency stop before the machine can be started. . When the machine does not start (observe whether the start indicator is lit), we check the status of each emergency stop button.
2. When the discharge roller is about to release the material, it must be decelerated in advance. It is guaranteed that the speed of the material is just zero when it is finished.
3. Deflating Adhere the material on the receiving roller with tape, open the pressing shaft, lift the receiving roller, place it on a stable place, deflate the receiving roller, and pull out the receiving roller.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc