Rewinding Machine safety operation guide -
Fourth, joint operator joint quality:
1 found that the paper has a broken rewinder
2 peel off the damaged paper that affects the quality at the break of the rewinding and rewinding paper roll, and draw the paper edge Qi.
3 first cut a piece of paper, paste double-sided tape (or according to process requirements)
4 Stick the other side of the paper together, cut the paper, and attach the connector label.
Automatic rewinding machine speed ratio adjustment method ---
The rewinding machine is the first station of the production line equipment of the welcoming machine. The good running condition of the rewinding machine directly affects the quality and production efficiency of the post-processing welcoming paper. The rewinding machine should be able to operate normally and in a good production state. In addition to the good and non-damage of the components, the reasonable adjustment and control of the transmission ratio of the whole machine is very important.
When the rewinding machine is produced, the original paper web is conveyed by five transmission rollers and belts, that is, a paper feeding belt, a curved roller, a rear platen roller, a front platen roller, a winding roller, and the like. Each of the base papers is thin, the elongation is limited, and the transmission speed ratio is unstable, and the paper web is easy to wrinkle and be broken during the continuous acceleration and deceleration operation of the winder. Reasonable adjustment and control of the speed of each drive roller and paper feed belt can greatly reduce the phenomenon that the paper web is broken. After many daily adjustments, the author summarizes the following key adjustment methods. 1. Stable paper feed belt conveys the line speed of the original paper web. The paper feeding belt of the rewinding machine is driven by the V-belt through the stepless speed-regulating wheel. When the output torque is large, the driving V-belt is close to the outer edge of the speed-regulating wheel, and the transmission speed will be more stable. In order to achieve such a stable transmission effect, the speed ratio of the main gearbox can be adjusted step by step to make the speed of the winding roller slower, and at the same time adjust the speed control handwheels of the paper feed belt of the original paper frame, so that the three sets of transmission triangle belts are in The outer edge of the stepless speed regulation wheel is in a reasonable position until the winding speed of the winding roller and the paper feeding belt are the same.
Design and application of constant tension and load distribution control for winder---
1. Rewinder structure and working principle
The rewinder is generally composed of a unwinding roll (also referred to as a paper take-off roll), a guide roll, a slitting mechanism, a platen roll, a take-up bottom roll (including a front bottom roll and a rear bottom roll), and a double bottom roll. The machine is characterized by two rotating drums to replace and support the take-up reel, usually with or without a rotating platen roller pressed against the top of the reel in the take-up, the take-up reel is taken up The main structure (has become the front and rear bottom rollers respectively). Under normal circumstances, the surface of the front bottom roller is rough, and the surface of the rear bottom roller is relatively smooth. They are connected to the motor through the reduction gear box. The platen roller, also called the load roller, acts to create a downward pressure whose pressure is the difference between its own weight and the load roller lifting pressure. The unwinding roller is composed of a leg paper holder, a unwinding roller coupling, a unwinding roller clamping mechanism, and a unwinding motor. Longitudinal cutters generally have book holders side by side on the same axis, mainly used to cut off the change. Cut a certain width of sheet paper to the required width as needed. Two tension sensors are placed on the tension roller to receive the web tension.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc