Rewinding Machine safety operation guide -
Fourth, joint operator joint quality:
1 found that the paper has a broken rewinder
2 peel off the damaged paper that affects the quality at the break of the rewinding and rewinding paper roll, and draw the paper edge Qi.
3 first cut a piece of paper, paste double-sided tape (or according to process requirements)
4 Stick the other side of the paper together, cut the paper, and attach the connector label.
Automatic rewinding machine speed ratio adjustment method ---
2. Adjust the paper-pressing gap of the platen roller so that the paper web can be smoothly conveyed between the paper feeding belt and the winding roller. The rear platen roller is the intermediate link of the paper web conveying process. If the adjusted gap is too small, the paper web is easy to wrinkle and sag. When the gap is too large, the three layers of paper are not combined together to facilitate delamination and fault, which affects the speed of the paper feed and Rewind quality. When adjusting the paper-pressing roller, the paper-pressing gap should be gradually increased from small to large, so that the paper web can be locked without sag and not drooping.
Design and application of constant tension and load distribution control for winder---
2. Main research content
(1) On the basis of understanding the working principle and production process of the rewinder, determine the AC drive configuration scheme of the rewinder and the common DC bus power supply mode.
(2) In view of the influence of the change of the winding diameter on the tension during the rewinding process and the phenomenon of paper break and loose paper during acceleration and deceleration, a composite tension control method combining direct tension and indirect tension is proposed, and the real-time calculation and dynamics of the winding diameter are designed. Torque compensation program that effectively corrects tension disturbances to ensure constant tension during rewinding
(3) Software and hardware design to complete the pressure control of the platen roller”
(4) After detailed analysis of the causes of the load distribution of the bottom roller motor before and after the detailed analysis, determine the master-slave control scheme of the two motors, design the load distribution control system.
(5) Establishing a profibus-Dp network system, designing communication between pLC and inverter! Op operation panel"
(6) Using STEP7 to design the software of the rewinder control system, using ProTool to compile the entire monitoring system screen"
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc