Double Side Tissue Tape

Double Side Tissue Tape

Rewinding Machine safety operation guide - 

Fourth, joint operator joint quality:

Joint quality control
1 tape should not be exposed; prevent sticking between sheets.
2 The outer sheet of the joint must be flattened, straightened without wrinkles, and the end surface is not protruding.
3 When the joint is cut, the paper edge shall not be larger than 5mm and neat.
4 The outer tape of the joint must be a straight line.
5 connector label placed at the joint
6 The number of joints should be less than the specified value.

Double Side Tissue Tape

Rewinding Machine operation safety regulations - 

First, the preparation work before starting
1. Clean up the dust on the machine;
2. Check the circuit of the machine (whether the circuit is damaged), whether the rotating parts (bearings, gears, etc.) are loose, whether the conveying belt is intact, whether the protective device is intact, if there is an abnormality, it needs to be replaced or reported to the workshop supervisor in time;
3. Is the amount of lubricating oil (butter, oil) of the rotating parts of the machine appropriate? Is the amount of white mineral oil on the perforating knife appropriate? If not enough, add the right amount of oil;

Double Side Tissue Tape

Rewinder mechanical structure and control process ---

Third, the rewinding machine control performance indicators
The rewinder is the last process in the papermaking process. The performance of the rewinder determines the quality of the finished paper roll. A complete rewinder must have the following properties:

3. Tension adjustment mechanism
It is generally believed that web tension control is one of the important factors affecting the tightness of the paper roll. The most important function of flattening the paper web during the rewinding process is the web tension, and the web tension must be kept stable before the paper can be avoided. The lateral movement of the web allows the rolled out finished paper roll to meet the requirements. However, the web tension is only affected when the finished paper roll is rolled up. Since we are using a double bottom roller lower paper rewinding machine, the paper web must pass through the back bottom roller to be wound on the paper roll. The roller will isolate most of the tension, and only a small amount of tension can be transferred to the finished paper roll, which means that if there is tension to control the hardness of the paper roll, if the hardness of the paper roll changes little, The tension will change a lot. The key factors affecting the hardness of the paper roll are the pressure of the platen roller and the torque difference between the front and rear bottom rollers. The effect of the web tension on the hardness of the paper roll is not great because it is not a critical factor. 4. Electric drive "flexible" start and proper speed program control The starting of the winder is of course smoother and better, so that the paper web can be prevented from being subjected to the impact of tension, and the breakage can be reduced and the paper roll can be improved. Rewind quality. In order to meet such requirements, we often add a given integrator to the speed and current of the speed regulation system. This is beneficial to the start of the winder. Through analysis, we can know that if the system is to start more smoothly, give The larger the time constant of the integrator, the better, so the integral time constant of a given integrator can be adjusted over a large range to suit the processing requirements.
From the above four points, we can see that the electronic control system must have adjustment skills to meet the rewinding process.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?