Double Side Adhesive Tape

Double Side Adhesive Tape

Rewinding Machine safety operation guide - 

Fourth, joint operator joint quality:

Joint quality control
1 tape should not be exposed; prevent sticking between sheets.
2 The outer sheet of the joint must be flattened, straightened without wrinkles, and the end surface is not protruding.
3 When the joint is cut, the paper edge shall not be larger than 5mm and neat.
4 The outer tape of the joint must be a straight line.
5 connector label placed at the joint
6 The number of joints should be less than the specified value.

Double Side Adhesive Tape

Rewinding Machine operation safety regulations - 

Second, the operation steps:

4, traction paper head, start switch paper, the paper passing through the following parts: curved rod - towel press paper knife in front of punching knife - punching knife - curved rod - felt paper stick - winding wheel (the whole process It is necessary to use jog feed or slow speed. When entering the punching knife, it is strictly prohibited to twist the paper into one or more layers, and pay attention to safety);
5. Set the number of production sections according to product specifications;
6. Take a bundle of paper tubes into the paper tube push-up rack of the machine, spread the paper tube, take one into the middle of the two winding wheels, (and then press the embossing stick), and slowly rotate the machine. Rewinding (the ropes bundled with paper tubes should be placed in accordance with the regulations, and should not be randomly placed);

Double Side Adhesive Tape

Rewinder mechanical structure and control process ---


Second, the main structure of the winder
2.1 Ejection Department
In the rewinder system, we installed the paper roll on the paper exit frame. In order to ensure that the width of the sides of the paper web is the same, we should be moving the seasoning when the paper roll is ejected. However, the paper roll in the new structure can be moved together with the paper exit frame, which ensures greater rigidity of the paper exit frame. In addition to manually moving the paper roll, we can also use the pneumatic, photoelectric device and electric method to adjust the axial movement of the paper exit frame, so that the cutting edge of the winder can be narrowed, and the manual adjustment can not be achieved. Requirements.
We have a coupling on the reel of the unwinding roll. When working, we can use a pneumatic device to connect the brake to the motor. We can know that when the high-speed winder is started, the required acceleration time from zero to 2000m/min can be completed within 50~60s, and the deceleration time required for braking is 40s. Or even shorter, so we need to consider the maximum diameter and the maximum braking speed of the paper-removing brake on the winder to reduce the paper loss of the paper-cut, or it will cause a lot of waste. In the selection of the brakes of the eject roll, we often use brakes for starting brakes, magnetic brakes and mechanical brakes. In the usual case, we use the combination of the brake motor and other brake devices. When we press the paper, the paper roll started by the DC motor can enter the acceleration and working state and can be operated by the braking of the DC motor. Control, the tension control of the paper web, in the case of emergency stop, we can use the DC motor and other brakes together to stop the paper roll at the fastest speed.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?