Rewinding Machine safety operation guide -
Fourth, joint operator joint quality:
Joint quality control
1 tape should not be exposed; prevent sticking between sheets.
2 The outer sheet of the joint must be flattened, straightened without wrinkles, and the end surface is not protruding.
3 When the joint is cut, the paper edge shall not be larger than 5mm and neat.
4 The outer tape of the joint must be a straight line.
5 connector label placed at the joint
6 The number of joints should be less than the specified value.
Rewinding Machine operation safety regulations -
Fifth, machine maintenance and hygiene
1. After the production is completed, first adjust the governor to zero, close the program switch, and finally turn off the power of the control box;
2. Use the air duct to blow the inside and outside of the machine and the electric box, and do not place any debris such as tools in the machine and the electric box.
3. Regularly repair and maintain the rotating parts of the machine (add some amount of oil or butter)
4. The hygiene of the machine area must be cleaned.
5. The waste paper is sent to the pulping station of the designated paper mill. The original paper core is neatly stacked in the specified paper barrel stacking area according to the specifications. The leather tape, waste paper and waste paper core are placed in the designated stacking area.
6, with the machine repair to do the regular maintenance of the machine main maintenance work.
Four release and one rewinding machine operation program ---
Fourth, normal shutdown and emergency stop
1. The emergency stop is faster than the normal stop speed. After the stop, the traction roller is automatically raised. The self-locking button is urgently deactivated. In the state of emergency stop, the machine cannot be started. We need to unlock the emergency stop before the machine can be started. . When the machine does not start (observe whether the start indicator is lit), we check the status of each emergency stop button.
2. When the discharge roller is about to release the material, it must be decelerated in advance. It is guaranteed that the speed of the material is just zero when it is finished.
3. Deflating Adhere the material on the receiving roller with tape, open the pressing shaft, lift the receiving roller, place it on a stable place, deflate the receiving roller, and pull out the receiving roller.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc