Heat Resistant Foam Tape

Heat Resistant Foam Tape

Rewinding Machine safety operation guide - 

Fifth, the tool change operation:
1. The bottom knife replacement is handled by the mechanic.
2. The rewinding machine must be stopped when the upper round knife is replaced.
3. After removing the round blade, replace the new blade and fix it.
4. Install the round knife seat, adjust the angle, and lower the round knife to make it close to the bottom knife.
5, running, paper test knife, paper edge is not, smooth.
6. The tightness and depth of the blade and the bottom knife should be controlled properly, not too tight, otherwise the new knife
The film will roll the knife; it should not be too loose, otherwise it will jump the knife and the hair; not too deep, otherwise it will cause double trimming; too shallow will jump the knife.

Heat Resistant Foam Tape

Rewinding Machine operation safety regulations - 

Fourth, other requirements in the production process:

5. When an abnormality or malfunction occurs in the production process, the machine must be turned off and checked and repaired. If the abnormality or failure is not handled, the workshop supervisor should be reported in time;
6. The perforation line must be inspected every half hour during the production process. If the perforation line is unqualified, it must be shut down immediately;
7. Every paper change must be weighed twice in the production process. If the weight of the original paper is quantitative, the texture and elongation are unstable, the number of knots should be adjusted at any time, the pressure of the riding stick should be adjusted, and the gearbox should be adjusted. The paper is elastically adjusted to meet the product diameter requirements, and the weighing is tracked to see if the weight of the product meets the standard.
8, at any time to patrol the quality of the product.

Heat Resistant Foam Tape

Four release and one rewinding machine operation program ---

Fourth, normal shutdown and emergency stop
1. The emergency stop is faster than the normal stop speed. After the stop, the traction roller is automatically raised. The self-locking button is urgently deactivated. In the state of emergency stop, the machine cannot be started. We need to unlock the emergency stop before the machine can be started. . When the machine does not start (observe whether the start indicator is lit), we check the status of each emergency stop button.
2. When the discharge roller is about to release the material, it must be decelerated in advance. It is guaranteed that the speed of the material is just zero when it is finished.
3. Deflating Adhere the material on the receiving roller with tape, open the pressing shaft, lift the receiving roller, place it on a stable place, deflate the receiving roller, and pull out the receiving roller.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com