Rewinding Machine safety operation guide -
Fifth, the tool change operation:
1. The bottom knife replacement is handled by the mechanic.
2. The rewinding machine must be stopped when the upper round knife is replaced.
3. After removing the round blade, replace the new blade and fix it.
4. Install the round knife seat, adjust the angle, and lower the round knife to make it close to the bottom knife.
5, running, paper test knife, paper edge is not, smooth.
6. The tightness and depth of the blade and the bottom knife should be controlled properly, not too tight, otherwise the new knife
The film will roll the knife; it should not be too loose, otherwise it will jump the knife and the hair; not too deep, otherwise it will cause double trimming; too shallow will jump the knife.
Rewinding Machine operation safety regulations -
Fifth, machine maintenance and hygiene
1. After the production is completed, first adjust the governor to zero, close the program switch, and finally turn off the power of the control box;
2. Use the air duct to blow the inside and outside of the machine and the electric box, and do not place any debris such as tools in the machine and the electric box.
3. Regularly repair and maintain the rotating parts of the machine (add some amount of oil or butter)
4. The hygiene of the machine area must be cleaned.
5. The waste paper is sent to the pulping station of the designated paper mill. The original paper core is neatly stacked in the specified paper barrel stacking area according to the specifications. The leather tape, waste paper and waste paper core are placed in the designated stacking area.
6, with the machine repair to do the regular maintenance of the machine main maintenance work.
Four release and one rewinding machine operation program ---
Second, the machine starts
1. Press the warning button and delay for about 2 seconds. At the same time, the alarm sounds, and then press the start button to start the machine.
2. When the machine starts, fine-tune the discharge roller to ensure that the material is flush at the receiving roller. During the fine adjustment process, the gear is not rubbed against the periphery.
3. When the machine is running, no objects are allowed between the ultrasonic probe and the material axis. This will cause the machine to stop working.
Third, automatic acceleration
When the accelerator button is pressed and delayed for about 3 seconds, the machine automatically accelerates to the required maximum speed (set in the touch screen), and the deceleration button is pressed once during the acceleration process to automatically accelerate and stop.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc