Rewinding Machine operating procedures -
First, the boot process:
4. Press the gas up axis button to inflate the gas riser shaft;
5, adjust the position of the left and right correction sensor, so that the correction position is 50%, cancel the paper-like
6. Open the stop tension maintaining function;
Note: Before opening the tension, ensure that the product has no obvious relaxation;
7. Set the running tension and automatic running speed separately;
(1) The tension is set according to the characteristics of the product. The cigarette pack is generally about 45N, the most
Do not exceed 60N;
(2) The maximum running speed should not exceed 200m/min;
Guolian High Speed ??Slitting Rewinder Technical Description ---
Third, the function introduction
1. The tension control of the eject roller consists of a tension sensor and an eject motor.
In the loop control loop, the paper take-off motor is an electric motor when unwinding, and is a brake generator during normal operation and parking.
2. The pressure control of the pressure roller is controlled by various sensors such as the take-up roller diameter detecting sensor.
Forming a closed-loop control system, there are three pre-made curves for different paper grades and different finished paper diameters for the operator to choose, and the actuator will be controlled according to these three different pressure curves.
3, between the two take-up bottom rollers, take the torque difference control method, corresponding to no
The same take-up diameter, the torque between the front and rear bottom rollers is distributed in different proportions.
Belt rewinding machine design and working principle ---
12Paper roll holder
When the paper roll is stopped, the paper roll is fixed at a certain position by the paper roll holder. The paper roll holder prevents slack and lateral movement of the paper roll. It is important to make a joint when making a customer roll. Roll holder on the take-up roll
The paper roll holder on the paper roll includes a spring-loaded plastic roll mounted on the paper cutter frame. When the paper cutter is in or on the middle position, the paper roll holder is placed against the surface of the rear bottom roller.
13 Automatic roll change
The rewinding device removes the paper roll from the winder.
The rewinding device cuts the sheet, pushes the paper roll onto the unloading station and fills in a new core for the rewinding.
The roll change can be started when the roll is decelerated. In the final stage of deceleration, the nipple guardrail and the platen roller rise to a high position. The unloader rises to the position where the paper roll is received. When the winder stops, the paper core clamp opens and rises to rise. The paper cutter is raised from between the paper rolls. The paper feed roller pushes the paper roll to the paper unloading station. At the same time, the paper cutter cuts the paper. The vacuum suction of the rear bottom roller sucks the cut sheet onto the roller. The core loader drops the new core onto the roll. The paper feed roller returns to its original position and the unloading table falls to the middle position. The paper core clip is lowered and closed. The platen roller and the nip guard are lowered. The winder crawls at a speed.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc