Infrared Reflective Tape

Infrared Reflective Tape

Rewinding Machine operation safety regulations - 

First, the preparation work before starting
1. Clean up the dust on the machine;
2. Check the circuit of the machine (whether the circuit is damaged), whether the rotating parts (bearings, gears, etc.) are loose, whether the conveying belt is intact, whether the protective device is intact, if there is an abnormality, it needs to be replaced or reported to the workshop supervisor in time;
3. Is the amount of lubricating oil (butter, oil) of the rotating parts of the machine appropriate? Is the amount of white mineral oil on the perforating knife appropriate? If not enough, add the right amount of oil;

Infrared Reflective Tape

Guolian High Speed ??Slitting Rewinder Technical Description ---

Third, the function introduction
1. The tension control of the eject roller consists of a tension sensor and an eject motor.
In the loop control loop, the paper take-off motor is an electric motor when unwinding, and is a brake generator during normal operation and parking.
2. The pressure control of the pressure roller is controlled by various sensors such as the take-up roller diameter detecting sensor.
Forming a closed-loop control system, there are three pre-made curves for different paper grades and different finished paper diameters for the operator to choose, and the actuator will be controlled according to these three different pressure curves.
3, between the two take-up bottom rollers, take the torque difference control method, corresponding to no
The same take-up diameter, the torque between the front and rear bottom rollers is distributed in different proportions.

Infrared Reflective Tape

Belt rewinding machine design and working principle ---

14 change roll
The roll change blower is used to blow the cut sheet onto the core. On the platen roller, there are three blowing tubes on the paper core with a blowing tube under the paper core. When blasting is used, the paper will bypass the core at the beginning of the machine.


15 paper cut hair dryer
The web cut blower is used when the web must be cut quickly. The blow tube is located between the guide rollers.
The blow tube is activated by a safety photocell or a manually transmitted pulse signal.
1- Spreading roller
2- Adjust the paper wrap angle device,
3- Stretch roller bending direction adjustment device
A- paper web
B- First stretch roll bending direction
C- second stretch roll bending direction
Stretching device
The stretching device on the illustration is the basic position of the display. The web A passes directly through the spreader roll, which means that the web curvature is zero. The first spreader roll B is at an angle of 90 degrees with respect to the sheet. The second spreader roll has a camber at the base position when the cylinder pressure is 0 bar. The cylinder pressure can be read on the meter at the location of the control system.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com