Rewinding Machine operation safety regulations -
Second, the operation steps：
7. When the layers of paper are completely flat and enter the rewinding, the waste coils are taken out to the normal production state. 8, check the production situation:
(1) Check whether the two ends of the base paper are symmetrical. For example, the auger can adjust the auger on the unloading frame to the ends of the paper. (2) Check whether the punched paper is clear, the punching is not clear or the missing teeth are checked. Whether the knife is broken or not
Whether the wire is loose, adjust the height of the bottom knife, and mass production after inspection;
(3) Check whether the paper feeding tension of the rewinding paper is consistent, keep the paper surface flat and no wrinkles, such as inconsistency
Then adjust the paper return belt hand wheel on the paper exit frame;
(4) Check whether the paper between the embossing stick and the winding area is flat and tight, if it meets the requirements, if it does not meet the requirements,
Then adjust the gearbox handwheel (when adjusting the gearbox handwheel, you can't stop the adjustment, you need to turn it on slowly); (5) Check whether the semi-finished paper roll is tight, the diameter and weight meet the product standard requirements, and the two ends are neat (straight
The deviation of the diameter shall not exceed ±1mm, and the weight deviation shall be within ±2);
(6) Whether the width of the glue seal of the paper ball meets the standard (package standard is 10mm-15mm), the penetration of glue
No more than 3 single-layer papers;
(7) Do not arbitrarily tamper with the inverter, programmed wiring and settings in the electric box; (8) Non-operator operators must not let the machine operate without the consent of the supervisor;
Third,. After the above steps are checked normally, Slowly speed up to normal operation.
Automatic rewinding machine speed ratio adjustment method ---
4. Adjust the internal toothed chain and external chain of the main gearbox to make the transmission of the whole machine more stable. When the roll paper rewinding machine is running, it is controlled by the automatic acceleration and deceleration program to start and stop frequently, and the automatic trimming and sealing operation is completed. Therefore, the stability of the gearbox transmission ratio is high. By tightening its internal and external chains, the chain can be prevented from slipping and skipping, making the speed ratio more stable during frequent acceleration and deceleration. The tensioned upper chain of the toothed chain can be moved up and down by a tool of about 5 to 8 mm.
Belt rewinding machine design and working principle ---
Measure the diameter of the exit roller.
The diameter measuring sensor or the super-sonic sensor is fixed on the floor in the middle of the paper exit. The sensor measures the diameter of the reel as the reel becomes smaller in the rack position.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc