Reflective Adhesive Tape

Reflective Adhesive Tape

Rewinding Machine operation safety regulations - 

Fourth, other requirements in the production process:

5. When an abnormality or malfunction occurs in the production process, the machine must be turned off and checked and repaired. If the abnormality or failure is not handled, the workshop supervisor should be reported in time;
6. The perforation line must be inspected every half hour during the production process. If the perforation line is unqualified, it must be shut down immediately;
7. Every paper change must be weighed twice in the production process. If the weight of the original paper is quantitative, the texture and elongation are unstable, the number of knots should be adjusted at any time, the pressure of the riding stick should be adjusted, and the gearbox should be adjusted. The paper is elastically adjusted to meet the product diameter requirements, and the weighing is tracked to see if the weight of the product meets the standard.
8, at any time to patrol the quality of the product.

Reflective Adhesive Tape

Design and application of constant tension and load distribution control for winder---

1. Rewinder structure and working principle
The rewinder is a paper roll produced by a paper machine, which is slit, finished, and re-rolled into a roll paper or other type of paper with a certain width and length and tightness to meet the printing memory package. Industrial needs. The performance of the rewinding machine will affect the output of the entire paper machine production line.
The rewinding machine has many forms. According to the nature of the reel, the rewinding machine can be divided into a shaft rewinding machine and a shaftless rewinding machine: according to different rotation modes, it can be divided into single motor transmission and double motor rotation. In this paper, we are transforming a double-bottom roll-feeding rewinding machine, each of which has its own motor drive.

Reflective Adhesive Tape

Belt rewinding machine design and working principle ---

Stretching device after cutting the web
The purpose of stretching after slitting is to stretch the sheet in the lateral direction and to separate the cut sheets from each other.
After the cut, the stretch is achieved by the wrap angle roll. The wrap angle roll includes a stretch roll. The first spreader roll is above the cut sheet and the second spreader roll is below the sheet. Both rollers are mounted on a frame that is used to adjust the stretch.
The spreader rolls above the sheet have good curvature. The spreader roll is equipped with a bend control device. The hand wheel and screw mechanism are used on the maintenance side to control the direction and tendency of the bend.
The segmented spreader rolls are under the sheet of paper. The segmented stretch roll is placed over an arcuate roll mounted on a steel beam. The cylinder is mounted below the segmented spreader roll. The bending curvature of the spreader roll can be modified by adjusting the gas pressure to adjust the cylinder.
Stretching principle:
When the sheet passes under the first roller, the sheet is guided from the center to the outside by a curved roller at each slightly different angle. At this time, there is a small gap between the cut sheets. When the sheet is placed over the second roll, the sheet encounters an arc of the opposite direction, which allows the sheet to remain parallel through the gap.
The stretching effect is mainly controlled by changing the wrap angle of the spreader roll. In addition, the stretching effect can also be controlled by changing the bow position of the stretch roll to control and change the arcuate curvature of the segmented spreader roll. The spreader roller is driven by a separate drive motor through a V-belt. The speed of the stretching roller is the same as the speed of the rewinding machine.
Measuring the exit roller diameter 1- Diameter measuring sensor 2- Support frame 3- Reel


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?