Floor Tape Machine

Floor Tape Machine

Four release and one rewinding machine operation program ---

Second, the machine starts
1. Press the warning button and delay for about 2 seconds. At the same time, the alarm sounds, and then press the start button to start the machine.
2. When the machine starts, fine-tune the discharge roller to ensure that the material is flush at the receiving roller. During the fine adjustment process, the gear is not rubbed against the periphery.
3. When the machine is running, no objects are allowed between the ultrasonic probe and the material axis. This will cause the machine to stop working.

Third, automatic acceleration
When the accelerator button is pressed and delayed for about 3 seconds, the machine automatically accelerates to the required maximum speed (set in the touch screen), and the deceleration button is pressed once during the acceleration process to automatically accelerate and stop.

Floor Tape Machine

Design and application of constant tension and load distribution control for winder---

1. Rewinder structure and working principle

1.1 Structure
The rewinder is generally composed of a unwinding roll (also referred to as a paper take-off roll), a guide roll, a slitting mechanism, a platen roll, a take-up bottom roll (including a front bottom roll and a rear bottom roll), and a double bottom roll. The machine is characterized by two rotating drums to replace and support the take-up reel, usually with or without a rotating platen roller pressed against the top of the reel in the take-up, the take-up reel is taken up The main structure (has become the front and rear bottom rollers respectively). Under normal circumstances, the surface of the front bottom roller is rough, and the surface of the rear bottom roller is relatively smooth. They are connected to the motor through the reduction gear box. The platen roller, also called the load roller, acts to create a downward pressure whose pressure is the difference between its own weight and the load roller lifting pressure. The unwinding roller is composed of a leg paper holder, a unwinding roller coupling, a unwinding roller clamping mechanism, and a unwinding motor. Longitudinal cutters generally have book holders side by side on the same axis, mainly used to cut off the change. Cut a certain width of sheet paper to the required width as needed. Two tension sensors are placed on the tension roller to receive the web tension.


Floor Tape Machine

Belt rewinding machine design and working principle ---


9 small paper rolls launched
The small paper roll ejecting device is used for those paper rolls that are too small for the paper feed roller. The small paper roll ejecting device is mounted on the paper feed roller. It relies on hydraulic pressure to move. The minimum diameter that the small paper roll exit can be pushed out is 200 mm (7.9 in).

10 paper cutter construction
The paper cutter is a zigzag blade, which cuts the slit webs during roll ejection. The paper cutter rises from the paper roll to the paper cutting position. The movement of the paper cutter is done by a lever driven by a hydraulic cylinder.
working principle 
The paper roll is pressed against the raised paper cutting blade by the ejector pin and cut.

11 core positioning pin
The end of the core loader is a paper core locating pin attached to the rewinder frame. The paper core positioning pin includes a metal plate and a frame. The scale on the core locating pin shows the position of the locating pin. The paper core locating pin holds the paper core in the correct position on the core loader only by the edge of the slitter. The core positioning pin is placed in close proximity to the slit and is locked in that position by the locking arm.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?