Rewinder mechanical structure and control process ---
Second, the main structure of the winder
2.1 Ejection Department
In the rewinder system, we installed the paper roll on the paper exit frame. In order to ensure that the width of the sides of the paper web is the same, we should be moving the seasoning when the paper roll is ejected. However, the paper roll in the new structure can be moved together with the paper exit frame, which ensures greater rigidity of the paper exit frame. In addition to manually moving the paper roll, we can also use the pneumatic, photoelectric device and electric method to adjust the axial movement of the paper exit frame, so that the cutting edge of the winder can be narrowed, and the manual adjustment can not be achieved. Requirements.
We have a coupling on the reel of the unwinding roll. When working, we can use a pneumatic device to connect the brake to the motor. We can know that when the high-speed winder is started, the required acceleration time from zero to 2000m/min can be completed within 50~60s, and the deceleration time required for braking is 40s. Or even shorter, so we need to consider the maximum diameter and the maximum braking speed of the paper-removing brake on the winder to reduce the paper loss of the paper-cut, or it will cause a lot of waste. In the selection of the brakes of the eject roll, we often use brakes for starting brakes, magnetic brakes and mechanical brakes. In the usual case, we use the combination of the brake motor and other brake devices. When we press the paper, the paper roll started by the DC motor can enter the acceleration and working state and can be operated by the braking of the DC motor. Control, the tension control of the paper web, in the case of emergency stop, we can use the DC motor and other brakes together to stop the paper roll at the fastest speed.
Design and application of constant tension and load distribution control for winder---
4 Research significance and content
Due to the application and development of frequency conversion technology and computer network technology in the field of industrial control, the establishment of AC drive control system based on field bus has become an effective way to solve the above shortcomings and limitations. Taking PLC as the control unit, the inverter is the execution unit, and the OP operation panel is the operating unit to form the all-digital field bus rewinder AC rotation control system. Based on this assumption, in order to reduce the investment, the original mechanical part and hydraulic part of the system are basically maintained, the original DC rotating system is transformed into an AC rotating system, the solenoid valve and some worn mechanical parts are replaced; and the OP270 man-machine interface is used instead of the machine. Buttons and analog meters, and a part of the mechanical buttons, so that workers can operate on the OP270 or on the console buttons, complement each other, increasing the flexibility of operation.
Belt rewinding machine design and working principle ---
9 small paper rolls launched
The small paper roll ejecting device is used for those paper rolls that are too small for the paper feed roller. The small paper roll ejecting device is mounted on the paper feed roller. It relies on hydraulic pressure to move. The minimum diameter that the small paper roll exit can be pushed out is 200 mm (7.9 in).
10 paper cutter construction
The paper cutter is a zigzag blade, which cuts the slit webs during roll ejection. The paper cutter rises from the paper roll to the paper cutting position. The movement of the paper cutter is done by a lever driven by a hydraulic cylinder.
The paper roll is pressed against the raised paper cutting blade by the ejector pin and cut.
11 core positioning pin
The end of the core loader is a paper core locating pin attached to the rewinder frame. The paper core positioning pin includes a metal plate and a frame. The scale on the core locating pin shows the position of the locating pin. The paper core locating pin holds the paper core in the correct position on the core loader only by the edge of the slitter. The core positioning pin is placed in close proximity to the slit and is locked in that position by the locking arm.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc