Auto Core Cutter

Auto Core Cutter

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Auto Core Cutter

Domestic cutting machine development status and outlets ---

1. Not rigorous in the manufacturing process
Tolerance control in the mechanical manufacturing process is not precise enough, and the surface is rough, especially in the matching electroplating industry, which is shoddy. There is a defect in the dynamic balance of the roller for cutting the Chinese-made equipment at one time. The lag of the related industry, the rubber coated by the roller has far less wear resistance and anti-aging than the foreign products. The bearings used seem to use well-known foreign brands, but the counterfeit and shoddy floods the domestic bearing market. Even when the real goods are purchased, the precision is far lower than the precision used by foreign slitting machines.
In the entire production process of a slitting machine, there is no guarantee of production process. At present, most of the slitting machines produced in China are completed by a number of outsourcing units, and the quality of their production is even more difficult to guarantee. In addition, the metal materials used and the heat treatment process are not rigorous enough, resulting in many problems in the use of a slitting machine. It has seriously affected the share of a slitting machine in the domestic market. The secondary and tertiary slitting machines have fewer problems than the one slitting machine, because the parts of the secondary and tertiary slitting machines are completed by the slitting machine manufacturer, and the dynamic balancing machine used is in a narrow range. It can accurately control the unbalanced grams, and the industrial difficulty coefficient of manufacturing is reduced. Its selling price is far lower than that of foreign products. Therefore, the proportion of domestically produced slitting machines in the domestic slitting machine market getting bigger.

Auto Core Cutter

Domestic cutting machine development status and outlets ---

2. Lack of composite professional talents who understand manufacturing technology and process and know cutting process
In the manufacturing process of the slitting machine, different customers are often faced with different materials and requirements. If different manufacturers produce the same materials, the raw materials used are not the same chemical plant products, and the physical properties of the materials produced are not the same. When producing the slitting machine, it cannot be generalized. In the production process, the manufacturing process will change, especially in the size of the roll diameter and the thickness of the coating layer, the difference between the active roller and the passive roller and the wrap angle of the roller surface, etc. The lack of corresponding research talents in the field often leads to many waste products and defective products in the slitting process. Such composite talents should not only be familiar with the design and manufacturing process of the entire slitting machine, but also understand the different characteristics of different materials during slitting. Currently, it is very scarce in China, which leads to the current situation of domestic slitting machines.
 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com