Automatic Jumbo Roll Bopp Tape Slitting Rewinding Machine

Automatic Jumbo Roll Bopp Tape Slitting Rewinding Machine

Slitting machine starts production
1. The winding roller is pressed down, the counter is cleared, and the production is started;
2. During the operation process, check the winding status of each joint from time to time, and adjust the tension according to the tightness of the winding to make each volume
The material is wound up and the end face is flush and firm;
3. Always pay attention to product quality during machine operation.
4. The machine has no abnormal sound.
5. Whether the photoelectric tracking operation is normal.
6. When checking the next volume, pay attention to check the surface of the product for quality defects and stick the tape as required.

Automatic Jumbo Roll Bopp Tape Slitting Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

four. Deviation
Deviation refers to the phenomenon that part of the film on the end face of the film roll is misaligned, which is caused by the sliding of the film during the winding process.

2. Causes and countermeasures of deviation:
(1) The problem of the quality of the slitting in the same category as the deviation of the end face is, in terms of degree, the degree of misalignment is more serious than the misalignment of the end face; in terms of nature, the general end face is not a continuous problem. However, the deviation is mostly an accidental problem; from the analysis of the reasons, the cause of the unevenness of the end face may cause the occurrence of the deviation problem.
(2) Since the deviation of the deviation from the end face is more prominent, the eye point should be placed in the fine point when the end face is not aligned. When analyzing the deviation problem, the eye point should be widened, especially the factor of the cutting speed. The effect is that the acceleration and deceleration are too rapid. For a film with good smoothness, it is easy to cause slippage and cause a split layer, and the slitting speed should be slowed down.
(3) For products with narrow slitting, too tight winding of the film roll will cause the film to slip laterally. If the film roll is too loose, air will be trapped, which will cause the film roll end to be staggered. Roll tension.

Automatic Jumbo Roll Bopp Tape Slitting Rewinding Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

nine. Scratch
      Whether the slitting and scratching can be compared and determined by the film surface before and after the slitting, there are various reasons for the scratching of the membrane surface, and the analysis should be based on the appearance of the scratch, such as short-line scratching. The difference of the speed ratio of each drive roller exceeds the process setting requirement, and it needs to be carefully tested and adjusted. If the film surface scratch occurs continuously, the film on the slitter should be inspected for whether it touches the fixed object or cuts each. Whether the roller adheres to dirt such as fine sand grains scratches the film surface.
Scratch is the appearance quality problem of the film, which directly affects the quality appearance of the deep-processed product. Therefore, it is not allowed to exist in the film quality control standard. The slitting process finds that the scratching problem must be carefully checked and quickly eliminated. Since the scratch on the film surface is an irreversible appearance quality problem, it is not allowed to operate the disease when the film surface is scratched, so as to avoid the continuous occurrence of the problem.
      

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com