Slitting machine starts production
1. The winding roller is pressed down, the counter is cleared, and the production is started;
2. During the operation process, check the winding status of each joint from time to time, and adjust the tension according to the tightness of the winding to make each volume
The material is wound up and the end face is flush and firm;
3. Always pay attention to product quality during machine operation.
4. The machine has no abnormal sound.
5. Whether the photoelectric tracking operation is normal.
6. When checking the next volume, pay attention to check the surface of the product for quality defects and stick the tape as required.
Reasons, countermeasures and effects of BOPP film slitting quality ---
twelve. Interface quality problem (poor interface quality, interface identifier does not match)
2. Interface identifier
Due to the large thickness of the film interface, the film roll for some applications must be properly handled at the interface to avoid unnecessary problems, such as slowing down, increasing the gap between the coating blade, and printing the offset plate. The interface products must be identified as necessary to facilitate customer identification and internal management.
1 The color of the adhesive interface is generally beige, special requirements are used according to the regulations. For example, Shanghai Ziquan requires the use of black adhesive tape; the marking method of the joint position is operated according to the regulations, such as Zhuhai Zhongfu Pearl Film, Shenzhen Ruimei The hot film is required to be marked at the ends of the interface with yellow paper dust protruding from the end of the film roll by about 1 cm; other special marks are operated according to the requirements of the production tribe.
2 Require the slitting workshop to mark the length number of the joint product without special requirements after the length of the label in the length column of the package label, and mark the “buter” mark on the note bar of the computer, and mark “+” on the remark column. Marking, pearl film and imitation paper film and exporting pearl film should indicate the length of each product before and after the joint on the length column of the product specification. For special requirements, the relevant marking work should be done according to the regulations (such as Shanghai Ziquan product port). The rate of less than or greater than 25% requires the number of interface products on each board product).
Slip axis and air shaft of slitting machine--
Sliding gas rising shaft structure characteristics and principle: Slip type gas rising shaft mainly consists of mandrel, airbag, slip sleeve and other parts.
Air enters the inside of the air bag to cause air expansion, pushes each torque group to expand outward, and sets the slip torque value of each torque group according to the inflation pressure, which is convenient for controlling the tension adjustment of each roll of material on the slitter. .
The slip type air rising shaft is mainly used for the striping equipment with high quality requirements and fast speed.
Slip-type air-up shaft technical parameters: slip-type air-up shaft main body outer diameter Φ75mm, action outer diameter Φ78mm, suitable for paper tube Φ76±0.2mm.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc