Slitting machine starts production
1. The winding roller is pressed down, the counter is cleared, and the production is started;
2. During the operation process, check the winding status of each joint from time to time, and adjust the tension according to the tightness of the winding to make each volume
The material is wound up and the end face is flush and firm;
3. Always pay attention to product quality during machine operation.
4. The machine has no abnormal sound.
5. Whether the photoelectric tracking operation is normal.
6. When checking the next volume, pay attention to check the surface of the product for quality defects and stick the tape as required.
Slitting machine operation guide ---
8.1 The cutting personnel shall record the production status in the “production record of the cutting machine” and other related records, insert the product into the “product tracking card”, and fill in the corresponding content in time according to the column and frequency requirements set in the record. The disk customers fill in the theoretical weight of each product for the weight of the product label of the Xiamen Cigarette Factory (see the attached table for the theoretical weight of each product), and the content is complete, clear, true and accurate.
8.2 Records should not be filled in with a pencil. The record holder should sign the quality record and indicate the time the record was filled.
8.3 The records listed in the record (except the remarks column) should be filled in. If the corresponding content is not found or there is no item, it can be recorded by slashing. The operator should write the full name and must not only write the last name.
8.4 Record changes caused by mistakes, etc. shall not exceed three pages per page. The records shall be clearly identifiable after the change. For all kinds of quality records that are validated and validated by the product and system, the change shall be stamped with a proofreading or marked change. people.
Domestic cutting machine development status and outlets ---
3. Lack of insight into the characteristics of different materials at the time of slitting, distinguishing between control systems and structures
Everyone knows that the physical properties of different materials are inconsistent. Some materials are smooth and firm. Some materials are very soft and soft, and the physical properties of the same material with different thicknesses are not the same. Among the slitting machines, the structure is also different, and there is a lack of changes in the control system due to its structural changes. The difference is rarely studied. In particular, the change in the difference in the control curve is even less known, and its mature control system software is still very few in China. Although some people have tried the application of a slitter control software, the chances of success are very low. Most of them are characterized by “headaches and pains.” Although our company has experienced 7-8 years of hard work, Some experience has been gained and the control system is becoming more mature, but there is still a certain gap compared with the materials covered by well-known foreign brands.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc