Cellophane Tape Production Machine

Cellophane Tape Production Machine

Slitting machine shutdown operation
1. After the cutting is completed, the unloading is stopped;
2. Release the switch and lift the cutter unit.
3. Clean the crimping device and turn off the curling blower.
4. Turn off the photoelectric tracking system.
5. Turn off the power and air supply of the whole machine.
6. Clean up the surrounding environment.
7. Carefully fill in the production daily record, product self-checklist and other work records.

Cellophane Tape Production Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

four. Deviation
Deviation refers to the phenomenon that part of the film on the end face of the film roll is misaligned, which is caused by the sliding of the film during the winding process.

2. Causes and countermeasures of deviation:
(1) The problem of the quality of the slitting in the same category as the deviation of the end face is, in terms of degree, the degree of misalignment is more serious than the misalignment of the end face; in terms of nature, the general end face is not a continuous problem. However, the deviation is mostly an accidental problem; from the analysis of the reasons, the cause of the unevenness of the end face may cause the occurrence of the deviation problem.
(2) Since the deviation of the deviation from the end face is more prominent, the eye point should be placed in the fine point when the end face is not aligned. When analyzing the deviation problem, the eye point should be widened, especially the factor of the cutting speed. The effect is that the acceleration and deceleration are too rapid. For a film with good smoothness, it is easy to cause slippage and cause a split layer, and the slitting speed should be slowed down.
(3) For products with narrow slitting, too tight winding of the film roll will cause the film to slip laterally. If the film roll is too loose, air will be trapped, which will cause the film roll end to be staggered. Roll tension.

Cellophane Tape Production Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Eight. Indentation
There are two reasons for the cause of film roll indentation. One is caused by the winding wheel of the film forming process, and the other is caused by the cutting factor. The reasons for the cutting are:
1 Due to the poor adjustment of the angle of the puller wheel, the pressure and tension of the puller wheel are concentrated on one point of the film, and the friction of the contact point causes damage to the film surface to form an indentation.
2 The winding roller is damaged, such as scratches, etc., the degree of film roll indentation is large when the scratch is longitudinal; 3 The winding roller is contaminated, causing the surface of the pressure roller to be uneven, such as adhesive tape, impurities, etc. It will also cause the film roll to be indented and the press roll must be cleaned.
Slight indentation does not affect the use of the product, but it affects the appearance of the product, causing the customer to doubt the quality of the product; the obvious indentation not only affects the appearance of the product, but also attenuates the corona value of the film, affecting the film. Processing performance.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com