Tape slitting machine feeding, filming and filming
1. Loading: According to the requirements of the cutting plan, according to the driving operation rules, according to the actual situation, hoist the corresponding mother roll on the aging frame, place it on the unwinding unwinding frame according to the inner and outer selection direction of the corona surface, and use the control button Clamp the steel core, leave the steel core support arm and drive.
2. Film penetration: When there is no film on the slitter, the film must be penetrated. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.
3. Film: When there is a film on the slitter, when changing the joint, use the vacuum filming table to start the filming station to the working position, manually flatten the film on the first pulling roller of the slitting machine and start the upper vacuum pumping film. Soak the film flat on the filming table, attach the double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding frame and start the lower vacuum pump to make the film flat and absorb the paper. Layer and flatten the adhesive film, the joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps to open the filming station to the inoperative position.
Reasons, countermeasures and effects of BOPP film slitting quality ---
twelve. Interface quality problem (poor interface quality, interface identifier does not match)
3. Interface length and interface rate requirements
Since the interface products will inevitably generate certain scraps before and after the interface, and the quality of the interface products cannot reach 100% of the quality level of the interfaceless products, increasing the loss of use, therefore, the film manufacturers and users are The number of interfaces of the volume product and the interface ratio of each batch of products are specified, so that the interface products are controlled within a certain range.
Slip axis and air shaft of slitting machine--
Sliding gas rising shaft structure characteristics and principle: Slip type gas rising shaft mainly consists of mandrel, airbag, slip sleeve and other parts.
Air enters the inside of the air bag to cause air expansion, pushes each torque group to expand outward, and sets the slip torque value of each torque group according to the inflation pressure, which is convenient for controlling the tension adjustment of each roll of material on the slitter. .
The slip type air rising shaft is mainly used for the striping equipment with high quality requirements and fast speed.
Slip-type air-up shaft technical parameters: slip-type air-up shaft main body outer diameter Φ75mm, action outer diameter Φ78mm, suitable for paper tube Φ76±0.2mm.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc