Adhesive Tape Roll Slitting Machine

Adhesive Tape Roll Slitting Machine

Tape slitter starts up
1. Change the specification, the paper core is on the inner and outer winding arms, and the pressure roller is in the ready state to notify all personnel to leave the machine and prepare to run.
2. Put the ANTI-STAIC BARS on the main console into AUTO, READY TO RUN is turned on, and start MACHINE RUN to start up.

Tape cutting machine cutting control
During the slitting operation process, carefully observe and observe the effect of cutting and cutting, and appropriately adjust and control the slitting speed, unwinding tension, contact pressure, curved roller, edge pulling roller and leading edge.

Adhesive Tape Roll Slitting Machine

Causes, countermeasures and effects on the quality of BOPP film slitting quality ---

(iv) Effect of film roll tightness on product quality

2. The volume is too loose:
1 Shift: Due to the looseness of the winding, the film roll is easy to move in series and shifts. If the degree is serious, it cannot be used.
2 Core-pulling: Due to the looseness of the winding, the film roll has serious end face misalignment near the paper tube during the loading or unloading or use process, commonly known as “core pulling”, which affects the appearance and use effect of the product.
3 The film wrinkles produced by the loosening of the rolls and the pit lines (stars) formed by the tightness of the inner pines affect the appearance quality and the use effect of the products to some extent.
4 Face wrinkles: Due to the looseness of the winding, the point support force of the end face of the film roll during the movement is reduced, and the fish scale-like end face wrinkles are easily generated.
5 Eccentricity: If the winding is too loose, the film roll will be eccentric (elliptical), and the unwinding tension will be uneven during the unwinding process, which will affect the use effect, especially the printing overprinting effect.

Adhesive Tape Roll Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Seven. Sharp edge
The curling occurs at the edge of the film winding, which causes the curling. The reason is that the edge of the thick film is curled up and the edge part is lifted up; the second is that the winding is too tight, and the tension can be shortened by slitting. Speed ??to improve the resulting edge curling phenomenon; third, the cutter is too blunt, and the stretching phenomenon occurs at the slit when slitting, causing the edge of the film roll to be turned outwards after winding to cause the curling edge, and the cutting should be replaced in time. The knife can avoid the occurrence of the curling problem; the fourth is that the tool is not installed correctly, such as the blade is close to the edge of the sipe and the blade is passivated. Cutting with a round knife can improve the curling of the film roll.
In the use of the unwinding process, there will be different degrees of side-floating in the unwinding process, and it is impossible to track the alignment with the electric eye, which directly affects the use effect. Therefore, it is necessary to change the product with the curled edge.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com