Four Shaft Tape Roll Cutting Machine

Four Shaft Tape Roll Cutting Machine

Tape slitter starts up
1. Change the specification, the paper core is on the inner and outer winding arms, and the pressure roller is in the ready state to notify all personnel to leave the machine and prepare to run.
2. Put the ANTI-STAIC BARS on the main console into AUTO, READY TO RUN is turned on, and start MACHINE RUN to start up.

Tape cutting machine cutting control
During the slitting operation process, carefully observe and observe the effect of cutting and cutting, and appropriately adjust and control the slitting speed, unwinding tension, contact pressure, curved roller, edge pulling roller and leading edge.

Four Shaft Tape Roll Cutting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)
1. Interface requirements
Due to poor interface, the quality of the film roll may be broken or wrinkled, which may cause adverse effects in the user's use. Therefore, the film interface must be connected to the specified specification to ensure the joint quality of the interface. Specific requirements are as follows: 
1 The two sections of the joint are cut and flattened horizontally, and the beige (or other specified color) adhesive tape with a width of 72 mm is firmly adhered to the front and back sides of the film;
2 In order to improve the interface quality, the film interface is required to be straight and balanced with the paper tube direction, and the interface is required to be flush and wavy. The interfaces at both ends are in the middle of the tape. Try to avoid the size of the edge. The adhesive tape is attached to the film. No obvious bubbles;
3 The film surface at the interface is required to be smooth without obvious wrinkling;
4 Do the identification of the joint position as specified.

Four Shaft Tape Roll Cutting Machine

Slitting machine operation guide ---

5 handling of abnormal conditions
5.1 Once the quality problem is found in the cutting process, it should be stopped immediately and recorded. The products that cannot be processed should be strictly distinguished, and the label should be marked and reported to the workshop to be handled by the monitor.
5.2 If the abnormal cutting process, abnormal smell, high temperature or sudden failure occurs, the machine should stop immediately. The machine personnel should fill in the “equipment failure repair order” and submit it to the squad leader for confirmation. Also recorded in the production record. 5.3 Timely feedback to the squad leader for problems that cannot be dealt with with quality, equipment, materials, and crafts.
5.4 Equipment failure Machine personnel should actively cooperate with the machine repair to debug, and record the equipment failure, the amount of damage, etc. in the "machine failure debugging consumption table", signed and confirmed by the machine personnel, the shift supervisor, and the machine repair class. The number of equipment faults after on-site confirmation is not included in the consumption assessment.
5.5 When the machine is running, it is strictly prohibited to be unattended.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com