Slitting machine instruction manual -
First, the basic parameters
1. Applicable nozzle length 80-120mm, diameter 5-8mm 2. Total machine power: 1.6kw, 380v 3ph
3. Dimensions: 8500*700*1700mm (L*W*H) 4. Weight: 500KG
Reasons, countermeasures and effects of BOPP film slitting quality ---
twelve. Interface quality problem (poor interface quality, interface identifier does not match)
2. Interface identifier
Due to the large thickness of the film interface, the film roll for some applications must be properly handled at the interface to avoid unnecessary problems, such as slowing down, increasing the gap between the coating blade, and printing the offset plate. The interface products must be identified as necessary to facilitate customer identification and internal management.
1 The color of the adhesive interface is generally beige, special requirements are used according to the regulations. For example, Shanghai Ziquan requires the use of black adhesive tape; the marking method of the joint position is operated according to the regulations, such as Zhuhai Zhongfu Pearl Film, Shenzhen Ruimei The hot film is required to be marked at the ends of the interface with yellow paper dust protruding from the end of the film roll by about 1 cm; other special marks are operated according to the requirements of the production tribe.
2 Require the slitting workshop to mark the length number of the joint product without special requirements after the length of the label in the length column of the package label, and mark the “buter” mark on the note bar of the computer, and mark “+” on the remark column. Marking, pearl film and imitation paper film and exporting pearl film should indicate the length of each product before and after the joint on the length column of the product specification. For special requirements, the relevant marking work should be done according to the regulations (such as Shanghai Ziquan product port). The rate of less than or greater than 25% requires the number of interface products on each board product).
Slitting machine operation guide ---
8.1 The cutting personnel shall record the production status in the “production record of the cutting machine” and other related records, insert the product into the “product tracking card”, and fill in the corresponding content in time according to the column and frequency requirements set in the record. The disk customers fill in the theoretical weight of each product for the weight of the product label of the Xiamen Cigarette Factory (see the attached table for the theoretical weight of each product), and the content is complete, clear, true and accurate.
8.2 Records should not be filled in with a pencil. The record holder should sign the quality record and indicate the time the record was filled.
8.3 The records listed in the record (except the remarks column) should be filled in. If the corresponding content is not found or there is no item, it can be recorded by slashing. The operator should write the full name and must not only write the last name.
8.4 Record changes caused by mistakes, etc. shall not exceed three pages per page. The records shall be clearly identifiable after the change. For all kinds of quality records that are validated and validated by the product and system, the change shall be stamped with a proofreading or marked change. people.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc