Thermal Transfer Ribbon Slitting Machine

Thermal Transfer Ribbon Slitting Machine

Slitting machine instruction manual -

Second, the use of procedures;
1. Check whether the parts of the machine are loose due to transportation and other reasons, adjust the four foot screws of the machine, and verify that the machine is level on the ground.
2. External high-pressure gas is supplied to the pressure regulating valve. The purpose of the second air pipe blowing is to eliminate the residual nozzle in the empty groove at the lower right of the drum, so that the drum can smoothly accept the new nozzle and adjust the pressure of the pressure regulating valve. The best use.

Thermal Transfer Ribbon Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---
two. Wrinkles (wrinkles, vertical wrinkles, cross wrinkles, wrinkles)

With the continuous improvement of slitting technology, the length of wrinkle is becoming less and less, and the products of individual manufacturers have achieved zero wrinkle, which undoubtedly grasps the opportunities in the fierce competition environment. It is worth noting that the wrinkles that we sometimes appear are not caused by the unreasonable setting of the cutting parameters, but because our operators are not responsible for the work, and the film is not attached to the paper tube but is free. After the film is put on the paper tube, it is turned on and cut, and the quality of the wrinkle is artificially created. It must be paid attention to, eliminate the defects of human quality and improve the quality of the product.

Thermal Transfer Ribbon Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Seven. Sharp edge
The curling occurs at the edge of the film winding, which causes the curling. The reason is that the edge of the thick film is curled up and the edge part is lifted up; the second is that the winding is too tight, and the tension can be shortened by slitting. Speed ??to improve the resulting edge curling phenomenon; third, the cutter is too blunt, and the stretching phenomenon occurs at the slit when slitting, causing the edge of the film roll to be turned outwards after winding to cause the curling edge, and the cutting should be replaced in time. The knife can avoid the occurrence of the curling problem; the fourth is that the tool is not installed correctly, such as the blade is close to the edge of the sipe and the blade is passivated. Cutting with a round knife can improve the curling of the film roll.
In the use of the unwinding process, there will be different degrees of side-floating in the unwinding process, and it is impossible to track the alignment with the electric eye, which directly affects the use effect. Therefore, it is necessary to change the product with the curled edge.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com