Slitting Machine Metal

Slitting Machine Metal

Slitting machine instruction manual -

Second, the use of procedures;
1. Check whether the parts of the machine are loose due to transportation and other reasons, adjust the four foot screws of the machine, and verify that the machine is level on the ground.
2. External high-pressure gas is supplied to the pressure regulating valve. The purpose of the second air pipe blowing is to eliminate the residual nozzle in the empty groove at the lower right of the drum, so that the drum can smoothly accept the new nozzle and adjust the pressure of the pressure regulating valve. The best use.

Slitting Machine Metal

Reasons, countermeasures and effects of BOPP film slitting quality ---

twelve. Interface quality problem (poor interface quality, interface identifier does not match)
1. Interface requirements
Due to poor interface, the quality of the film roll may be broken or wrinkled, which may cause adverse effects in the user's use. Therefore, the film interface must be connected to the specified specification to ensure the joint quality of the interface. Specific requirements are as follows: 
1 The two sections of the joint are cut and flattened horizontally, and the beige (or other specified color) adhesive tape with a width of 72 mm is firmly adhered to the front and back sides of the film;
2 In order to improve the interface quality, the film interface is required to be straight and balanced with the paper tube direction, and the interface is required to be flush and wavy. The interfaces at both ends are in the middle of the tape. Try to avoid the size of the edge. The adhesive tape is attached to the film. No obvious bubbles;
3 The film surface at the interface is required to be smooth without obvious wrinkling;
4 Do the identification of the joint position as specified.

Slitting Machine Metal

Slitting machine operation guide ---

8.1 The cutting personnel shall record the production status in the “production record of the cutting machine” and other related records, insert the product into the “product tracking card”, and fill in the corresponding content in time according to the column and frequency requirements set in the record. The disk customers fill in the theoretical weight of each product for the weight of the product label of the Xiamen Cigarette Factory (see the attached table for the theoretical weight of each product), and the content is complete, clear, true and accurate.
8.2 Records should not be filled in with a pencil. The record holder should sign the quality record and indicate the time the record was filled.
8.3 The records listed in the record (except the remarks column) should be filled in. If the corresponding content is not found or there is no item, it can be recorded by slashing. The operator should write the full name and must not only write the last name.
8.4 Record changes caused by mistakes, etc. shall not exceed three pages per page. The records shall be clearly identifiable after the change. For all kinds of quality records that are validated and validated by the product and system, the change shall be stamped with a proofreading or marked change. people.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com