Horizontal Slitting Machine

Horizontal Slitting Machine

Slitting machine instruction manual -

Second, the use of procedures;

3. Connect the external three-phase power supply, open the key switch placed on the operation button box, the green light on the right indicates that the power supply has been normally turned on, and the black knob adjuster placed on the corner box of the operation button is the small puller in the upper right corner of the control wheel drum. The speed of the motor is adjusted to the speed of the small puller by turning the knob. In actual use, the knob is adjusted to the highest (clockwise direction).

Horizontal Slitting Machine

Slitting machine operating procedures -

Third, through the film:

9. Press “Device Jog” again, and the film on both sides will be flattened until the slitting film appears on the winding side 2, and the film is cut with a knife.
10. Manually pull the slit film on the winding side 1 and the winding side 2, bond the film to the corresponding paper core, and tighten the film and stick the flat film to the paper core (note the side 1 and side 2 films). Wearing different methods).
11. Manually adjust the leading edge probe into position.
12. Set the winding length and winding diameter on the operation screen (see the preset length and diameter method for details)

Horizontal Slitting Machine

Reasons, countermeasures and effects of BOPP film slitting quality ---

Seven. Sharp edge
The curling occurs at the edge of the film winding, which causes the curling. The reason is that the edge of the thick film is curled up and the edge part is lifted up; the second is that the winding is too tight, and the tension can be shortened by slitting. Speed ??to improve the resulting edge curling phenomenon; third, the cutter is too blunt, and the stretching phenomenon occurs at the slit when slitting, causing the edge of the film roll to be turned outwards after winding to cause the curling edge, and the cutting should be replaced in time. The knife can avoid the occurrence of the curling problem; the fourth is that the tool is not installed correctly, such as the blade is close to the edge of the sipe and the blade is passivated. Cutting with a round knife can improve the curling of the film roll.
In the use of the unwinding process, there will be different degrees of side-floating in the unwinding process, and it is impossible to track the alignment with the electric eye, which directly affects the use effect. Therefore, it is necessary to change the product with the curled edge.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com